Trailer Brake and Prodigy Question
I have a 05 335rlbs. It has been towed about 350 miles so far. My friend and I adjusted the brakes today and decided that the best jacking point was on the bracket/point where the two springs and shackles are connected as this is a cast piece and goes directly to the chassis frame. We only raised the coach enough to get the tires free to rotate.
One tire seemed to need a good bit of adjustment to get it where it would only rotate about 1 turn when spun. THe other were very close to that already.
When I reconnected I went to adjust my prodigy to a point just before lock up. A point I have never been able to reach in the past no matter what setting or numerical number I set it to. Today was not different except that now if I set it too high or try it manually it will start braking and then the trailer brakes release and I get a LO reading or a SH. THis makes no sense as we did not touch any wiring. Further I have never seen those before. Also I cannot set my Prodigy level above about 6.8 or 6.9 with out getting that code. Whether manually or with truck brakes as well.
Many of you use prodigy and have a lot more experience that I do so I need some help as to how to interpret these codes and the actions to take or what. I cannot beleive the jack point nor the adjustment would cause these.
Thanks
|