Front leg issue
When setting up, I get the front legs up about 5" to 6", I start hearing a clicking noise after the pressure is off the hitch plate and the load is totally on the legs. As I move higher, the frequency of the clicks increases. If I were at the maximum height, I would assume the clicks would indicate that I had reached the maximum. However, this occurs with at least 6" to 10" of extention potential remaining.
I have been told that there are two size motors that drive the legs and that this may be the smaller one and is overloaded, so the "clutch" is slipping. Since I am not fully loaded, this could be a problem. Hand cranking up or down is not enjoyable.
I have not been into the mechanism yet and do not fully understand its operation. Please advise.
|