Quote:
Originally Posted by Ironchungis
How did you mount the steel bracket? Did you just put the bolt through the wall anywhere or were there specific spots you had to put them? Also did you just mount the pulley system to the steel bracket or through the wall too? I just had the same thing happen to mine.
|
As JIM65 mentioned, Remove the existing bracket, removed that 1/8" of fiberwood board over the frame. Drill out existing holes for the steel bracket and install the rivnuts. Then reinstall the bracket making sure the bracket is touching the rivnuts. Might plan on putting a washer between the steel bracket and the rivnut. tighten the bolts but not over tighten.