|
06-18-2022, 09:24 AM
|
#1
|
Montana Master
Join Date: Apr 2006
Location: Mesa az
Posts: 2,977
M.O.C. #5651
|
How to replace microwave
Not sure if every rig is the same, but my microwave is hung from the cabinet above by (I think) 2 bolts. Is that all there is to it? Also, if I buy another unit that fits in the space, do all microwaves have brackets that would mount from above like this??
Also, I assume I would need some muscle helper to hold the thing in place while tightening the bolts.
Any advice would be greatly appeciated.
__________________
Tom and Gail
2013 Mountaineer 362
2012 Silverado 2500
|
|
|
06-18-2022, 12:32 PM
|
#2
|
Montana Master
Join Date: Sep 2013
Location: Pensacola (mail forward service)
Posts: 3,198
M.O.C. #13740
|
No, those bolts are not all there is. The microwave is mounted via a mounting plate that is on the back wall as well. You will need to build a platform that sits on the stove or whatever is below your microwave to support it as you remove those bolts into the cabinet above as well as support the new one for its install. The replacement should come with a new wall bracket as well. Not a bad project except finding a new one to fit the spot of the old one.
__________________
2012 F350 6.7 L dually, 2013 3800RE with 6 pt leveling, Sumitomo 17.5" load range h tires, Samsung 18 cu ft residential fridge, 8k Morryde I.S. with disc brakes. Full timing since 2012.
|
|
|
06-18-2022, 01:28 PM
|
#3
|
Montana Master
Join Date: Feb 2012
Location: Lake Gaston
Posts: 8,773
M.O.C. #12156
|
I have replaced three times over the years. At least with Whirlpools, I was able to use the existing wall mount each time. Simply set the vent, the wall mount is a hook setup, drop the back of the microwave onto the mount, swing up, and there are two bolts through the cabinet into the top of the microwave. On one install, I did have to drill holes as the existing ones did not match up. MWs for the most part come in standard sizes, and I had no problems finding one that fit.
__________________
Mike and Lorraine
2002 3655 FL, 2005 3650RK
2010 3665RE, 2015 3910FB
F350 crew cab dually 6.7
|
|
|
06-19-2022, 12:03 PM
|
#4
|
Montana Master
Join Date: Apr 2006
Location: Mesa az
Posts: 2,977
M.O.C. #5651
|
My microwave is 1.5 cubic feet, I think. I searched the net and found 2 rv parts companies. I don't think there was a single 1.5 cf unit. Almost all were 1.1 and ALL were out of stock!!!!! Also, my unit is 30 inches wide and the ones above were 24 inches or smaller!!!
Do standard microwaves from a store fit??? Thanks
__________________
Tom and Gail
2013 Mountaineer 362
2012 Silverado 2500
|
|
|
06-19-2022, 12:19 PM
|
#5
|
Montana Master
Join Date: Oct 2012
Location: Box Elder
Posts: 4,735
M.O.C. #12947
|
I replaced our 30 inch microwave a couple years ago with a standard residential microwave I purchased at BestBuy, and other than drilling a couple new holes in the cabinet and installing the new mounting plate on the wall, the installation went fine. The cu ft measurement is strictly how they are designed inside, and the new unit we installed actually has more room inside than the old one. The original unit was a microwave/convection oven and we went with a microwave only unit and it has more power than the combination oven had.
__________________
Bob & Becky
2012 3402RL
2012 Chevy 2500HD D/A CC 4WD
|
|
|
06-19-2022, 12:30 PM
|
#6
|
Montana Master
Join Date: Oct 2012
Location: Box Elder
Posts: 4,735
M.O.C. #12947
|
The microwave we installed is a Samsung, and this was in March of 2020.
__________________
Bob & Becky
2012 3402RL
2012 Chevy 2500HD D/A CC 4WD
|
|
|
06-19-2022, 12:35 PM
|
#7
|
Montana Master
Join Date: May 2019
Location: Alton
Posts: 2,763
M.O.C. #24086
|
When we replaced ours, we used leveling blocks to hold it up during removal/installation.
__________________
Daryl and Marianne,
2019 3130re 20th Anniversary Edition
2016 F350 Lariat
|
|
|
06-19-2022, 01:48 PM
|
#8
|
Montana Fan
Join Date: Apr 2019
Location: Columbia
Posts: 303
M.O.C. #23739
|
Quote:
Originally Posted by twindman
My microwave is 1.5 cubic feet, I think. I searched the net and found 2 rv parts companies. I don't think there was a single 1.5 cf unit. Almost all were 1.1 and ALL were out of stock!!!!! Also, my unit is 30 inches wide and the ones above were 24 inches or smaller!!!
Do standard microwaves from a store fit??? Thanks
|
They are standard Over the range microwaves. They are all 30” find one that’s about the same height and you’ll be fine. The cubic foot is the interior size not the overall size. You can get one at Home Depot or lowes or wherever. The only issue is the bracket on the back wall might need to be replaced and the holes in the cabinet might need to be drilled in a different location. Other than that it take less than 45 min to swap and you don’t need to build anything to hold it. They aren’t that heavy.
|
|
|
06-22-2022, 03:14 PM
|
#9
|
Montana Fan
Join Date: Dec 2020
Location: Full Timer
Posts: 121
M.O.C. #27665
|
I’m considering a MW replacement too…how does the vent hook up? Do all vented MWs have the vent in the same spot, to line up with the existing RV vent hole?
Thanks in advance!
__________________
Full-Timing since 2018 in a 2013 3625RE, 2023 Ford F450DRW with High Output Diesel,
Custom kingpin-mounted hitch receiver for bike rack 2019
MorRyde I/S with 8K Axles & Goodyear G114 Tires on 17.5” aluminum wheels 2020
FlexArmor roof 2021, Starlink
|
|
|
06-22-2022, 03:20 PM
|
#10
|
Montana Fan
Join Date: Apr 2019
Location: Columbia
Posts: 303
M.O.C. #23739
|
Quote:
Originally Posted by VagabondLove
I’m considering a MW replacement too…how does the vent hook up? Do all vented MWs have the vent in the same spot, to line up with the existing RV vent hole?
Thanks in advance!
|
Normally the vents are in the same place right in the center.
|
|
|
06-22-2022, 09:47 PM
|
#11
|
Montana Master
Join Date: Oct 2012
Location: Box Elder
Posts: 4,735
M.O.C. #12947
|
Even with our original MW, the exhaust did not line up exactly with the vent through the wall, and when I installed the new unit, the exhaust lined up off center with the vent to the outside, but I did not mess with trying to move anything, it worked OK before and still does with the new unit. The new MW was set up to exhaust to the top of the unit, but there was instructions how to change the exhaust to the back.
__________________
Bob & Becky
2012 3402RL
2012 Chevy 2500HD D/A CC 4WD
|
|
|
06-23-2022, 07:10 PM
|
#12
|
Montana Master
Join Date: Apr 2006
Location: Mesa az
Posts: 2,977
M.O.C. #5651
|
After more research, my old unit was 15 3/4 inches high. The stove cover folds up and clears by about 3/4 to 7/8 inch. So the max height microwave I can use is around 16 1/4 or MAYBE 16 3/8. Only a few models are this size, but I am looking at HomeDepot or BestBuy 1000 miles from here where I am also replacing my A/C!!
Waiting for the dealer to get back if they will go pick it up if I order it online.
Thanks to all who offered help here.
__________________
Tom and Gail
2013 Mountaineer 362
2012 Silverado 2500
|
|
|
06-24-2022, 06:34 AM
|
#13
|
Montana Master
Join Date: Jan 2006
Location: San Antonio
Posts: 1,299
M.O.C. #5165
|
We replaced our 2006 microwave/convestion oven last week. I don't know when Keystone switched to home microwave ovens--30 inches wide. Ours was limited to about 21 inches. Still able to get a smaller microwave--Furrion--via Texas RV Supply in San Antonio. The original simply sat on a shelf above the vent-a-hood/stove. A few screws and it came out--weighs about 45 lbs! New one sat on the same shelf and attached to the front--yes it took a little rigging to secure it--but got it done--and then plugged it in. Works great. Ready for a great summer--also got plank flooring!
__________________
F-250 King Ranch Crew Cab 2012, Single Wheel, 6.7 L Diesel, Transfer Flow Internal 50 Gallon Fuel Tank, Upgraded Ford Software for 50 Gallon tank, 2006 3475Rl with Mor-ryde King Pin, 2nd AC, 2nd Battery, Pressure Pro TPMS, Wet Bolt Shackle Kit
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|