|
|
01-29-2018, 05:59 PM
|
#21
|
Established Member
Join Date: Dec 2017
Location: Hollywood Md
Posts: 25
M.O.C. #20930
|
No rear bumper, However you could have rack that acts as a bumper and storage area. There is a capacity of 300Lbs including the rack.
Here is a pic of the back of mine. No rack currently however I will be fabricating one from Aluminum soon.
|
|
|
01-29-2018, 11:09 PM
|
#22
|
Seasoned Camper
Join Date: May 2016
Location: Glen Alpine
Posts: 52
M.O.C. #18569
|
Quote:
Originally Posted by Dusters
Does anyone have a walk around to get the BCM to sync with the monitor on days it won't connect?
Back info: Power gen running (10.7 VDC min rqd), sync'd up to extend two of the electric slides, 15 minutes later no BCM sync. Powered down (computer reboot theory) several times and after another 20 minutes or so went to the manual switches on the board to close up the unit. The Red LED stayed on at the module, if I recall a blue LED should appear when sync'd.
This tends to happen about once a year and then just works after a little patience. The board was replaced last year while at the dealer for it's annual physical. I'm guessing for an industry post or recall.
|
Henry,
The only thing I could offer is the reset button in the center of the relay board. I have had one time in 2 years that I lost connectivity between the BCM and DC and wasn't able to reconnect with DC reboot. The reset button on the BCM worked perfectly in that condition. If you are seeing this about once per year the reset may be useful.
Now, on the hard wired connection between the 2, I'm jealous and will contact ASA to see what I can do to make that happen if possible. Always felt it should be a wired data connection for that part of the system.
John - 2016 3820FK
|
|
|
01-30-2018, 04:27 AM
|
#23
|
Established Member
Join Date: Oct 2017
Location: Westland
Posts: 22
M.O.C. #20703
|
Do not forget with the Legacy package you also get solid wood cabinets.
|
|
|
01-30-2018, 06:15 AM
|
#24
|
Montana Master
Join Date: May 2011
Location: Hixson
Posts: 3,436
M.O.C. #11397
|
Quote:
Originally Posted by Jersey Devil
Does the legacy come with a rear bumper?
I thought I read someone said no with the rear cap.
If so not good if someone hits it in the rear even a light tap will probably be costly.
|
The Legacy package on the 3790/3791RD does not include a rear cap but does include a 2" receiver. If someone hits it in the rear the cost is their problem because they are at fault.
__________________
2018.5 Montana 3791RD
Full Timers 9/1/2010 through 1/16/2020.
|
|
|
01-30-2018, 04:02 PM
|
#25
|
Montana Fan
Join Date: Sep 2016
Location: West Melbourne
Posts: 314
M.O.C. #18980
|
My 3160RL legacy comes with a flimsy 1 1/4” hitch receiver on the rear. I wish I had your 2” hitch.
__________________
Butch and Kathy
2016 3160RL Legacy, Sailun S637, Centramatic Balancers, 2-T105s, Amish Refrigeration, ARPrv, SoftStartRV, FlexArmor roof
2016 F350 6.7L SRW
|
|
|
01-30-2018, 05:33 PM
|
#26
|
Site Team
Join Date: Apr 2017
Location: Colorado Rockies
Posts: 1,993
M.O.C. #19755
|
Quote:
Originally Posted by Butchy
My 3160RL legacy comes with a flimsy 1 1/4” hitch receiver on the rear. I wish I had your 2” hitch.
|
Mine too. I've thought about putting a bicycle back there, but I don't think it would hold anything over 50Lb.
__________________
Scott & Alta
2017 Montana 3160RL, Legacy, Onan 5.5Kw, Solar
2022 F-450 Lariat Ultimate
|
|
|
02-04-2018, 09:58 AM
|
#27
|
Montana Fan
Join Date: Feb 2018
Location: Arlington
Posts: 136
M.O.C. #21176
|
Mine came with the legacy package but have had several times that it had to reboot. Sometimes it takes a long time and several reboots to get it to work.
|
|
|
02-04-2018, 01:13 PM
|
#28
|
Montana Master
Join Date: May 2011
Location: Hixson
Posts: 3,436
M.O.C. #11397
|
Quote:
Originally Posted by Curtis
Do not forget with the Legacy package you also get solid wood cabinets.
|
I would have to see cabinets from a Legacy and a Non-Legacy side by side to be convinced there is any difference in them. I checked the cabinets in our Non-Legacy 3791RD and can't find wrapped particle board anywhere. I can't say what kind of wood it is but it is solid wood.
__________________
2018.5 Montana 3791RD
Full Timers 9/1/2010 through 1/16/2020.
|
|
|
02-23-2020, 02:26 PM
|
#29
|
Established Member
Join Date: Aug 2019
Location: Cambridge
Posts: 18
M.O.C. #24738
|
I tried to remove the password on my 2020 3120RL Legacy, but it seems impossible now. Perhaps new software. But after following the instructions here, it forces me to create a new password.
__________________
Sandy & Steve
2020 Montana 3120RL, Legacy (Paint, Onan, Solar, Modern Maple)
2017 F350 Platinum 6.7 FX4 SRW SB (Pullrite Superglide)
|
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|