|
05-08-2010, 09:10 AM
|
#1
|
Seasoned Camper
Join Date: Apr 2010
Location: Panama City
Posts: 76
M.O.C. #10337
|
No 120VAC in Living slide.
We've been in our Monty a week today. Bought it used from an individual. We have found a few minor issues. Like needing a new AC thermostat. But that's fixed.
One problem is I have no 120 in the Couch/Dining slide.
So far I have found an electrical box on the frame under the slide which supplies the slide. A water tight flexible conduit runs out of the box under the house.
The breaker is good. I even checked the voltage coming out of the breaker.
The question is where do I look for the other end of that conduit? Is there a termination box other than the breaker box?
Thanks in advance.
Bill
|
|
|
05-08-2010, 04:13 PM
|
#2
|
Seasoned Camper
Join Date: Apr 2010
Location: Panama City
Posts: 76
M.O.C. #10337
|
Thanks Just!
It's dark and rainy out there right now. I'll check it out tomorrow.
When you say under the hitch, Do you mean the hatch the generator is usually in?
|
|
|
05-09-2010, 05:14 AM
|
#3
|
Seasoned Camper
Join Date: Apr 2010
Location: Panama City
Posts: 76
M.O.C. #10337
|
Whoa! We're really on the wrong page.
My problem is no 120Volts lighting electricity in the couch/dining slide out. When I try to turn on the 120VAC light above the dining table it doesn't light up. Also the 110 outlets in that slide don't work.
|
|
|
05-09-2010, 05:47 AM
|
#4
|
Montana Master
Join Date: May 2003
Location: New Bern
Posts: 4,295
M.O.C. #311
|
I would check the junction box on the frame under the slide. Check for power there. If so then you have to pull each outlet and light and check for loose wire. Good luck.
|
|
|
05-09-2010, 07:08 AM
|
#5
|
Seasoned Camper
Join Date: Apr 2010
Location: Panama City
Posts: 76
M.O.C. #10337
|
Quote:
quote:Originally posted by H. John Kohl
I would check the junction box on the frame under the slide. Check for power there. If so then you have to pull each outlet and light and check for loose wire. Good luck.
|
Already found that one and checked it. No Voltage there. But I have voltage at the breaker in the breaker/converter panel.
I'm thinking there must be another junction box some where between the breaker and that junction box. Just can't find it.
|
|
|
05-09-2010, 07:43 AM
|
#6
|
Montana Master
Join Date: May 2003
Location: New Bern
Posts: 4,295
M.O.C. #311
|
Quote:
quote:Originally posted by cbgaloot
Quote:
quote:Originally posted by H. John Kohl
I would check the junction box on the frame under the slide. Check for power there. If so then you have to pull each outlet and light and check for loose wire. Good luck.
|
Already found that one and checked it. No Voltage there. But I have voltage at the breaker in the breaker/converter panel.
I'm thinking there must be another junction box some where between the breaker and that junction box. Just can't find it.
|
Sorry, did not read that. Back to the circuit breakers. Did you check to make sure all the screws were tight.
I suggest you call Keystone Service and ask them if they install a junction box. Worse case you have to pull the belly pan and chase the wires backwards. Boy I would not want to do that. Just thinking out loud. Good luck. Let us know what you find.
|
|
|
05-09-2010, 11:11 AM
|
#7
|
Seasoned Camper
Join Date: Apr 2010
Location: Panama City
Posts: 76
M.O.C. #10337
|
Quote:
quote:Originally posted by H. John Kohl
Worse case you have to pull the belly pan and chase the wires backwards.
|
OH, God! I hope I don't have to do that.
|
|
|
05-09-2010, 12:19 PM
|
#8
|
Montana Master
Join Date: Sep 2006
Location: Casa Grande
Posts: 5,369
M.O.C. #6333
|
Bill, Could you possibly have a GFCI tripped? When mine trips I lose power in that slide. Just something else to check.... Seems strange to have power to the breaker and not the receptacles, unless you have a wire that was inadvertently cut. I know sometimes the factory has run these lines near the metal frames without protection.....And constant movement may have severed a wire or two.
|
|
|
05-09-2010, 02:29 PM
|
#9
|
Site Team
Join Date: Aug 2007
Location: Omaha
Posts: 6,795
M.O.C. #7560
|
Well Phil beat me to it! I'd chaeck all of the GFCIs and see if any are tripped! You never know what circuit those lights might be on and if there is a GFCI tripped somewhere it will cancel out anything on that line or circuit! Not to be a smart a--, but do you have a wall switch that controls your lights for that also? I know my 110 light in the living room are on a wall switch and I think my 12V/110 are also but it's been a whole 5 months now since I've been in the Monte and you know what they say about "oldtimers"!! I'd check out the GFCI and then the switch for a loose wire on it before digging into the depths of the belly! Keep us informed on what you find!!
|
|
|
05-09-2010, 02:33 PM
|
#10
|
Seasoned Camper
Join Date: Apr 2010
Location: Panama City
Posts: 76
M.O.C. #10337
|
Quote:
quote:Originally posted by exav8tr
Bill, Could you possibly have a GFCI tripped? When mine trips I lose power in that slide. Just something else to check.... Seems strange to have power to the breaker and not the receptacles, unless you have a wire that was inadvertently cut. I know sometimes the factory has run these lines near the metal frames without protection.....And constant movement may have severed a wire or two.
|
BINGO! exav8tr is King of the Forum!
The GFCI next to the kitchen sink was tripped. All the lights and outlets in the slide are working now.
I'll have to check that GFCI's wiring. You can usually wire them to remove power from all circuits down line or not. I don't see a need for removing power from the slide.
Thanks very much for the help Ex-aviator!
|
|
|
05-09-2010, 03:03 PM
|
#11
|
Montana Master
Join Date: Sep 2006
Location: Casa Grande
Posts: 5,369
M.O.C. #6333
|
I love it when a plan comes together... Glad to have helped... Just don't know why Keystone wired all these circuits on the GFCI Plug. Makes no sense, but it is what it is.
|
|
|
05-09-2010, 03:52 PM
|
#12
|
Montana Master
Join Date: Sep 2003
Location: Sunshine
Posts: 1,445
M.O.C. #538
|
I replaced the CFCIs with new units that have a red LED to show when they are tripped.
|
|
|
05-09-2010, 05:12 PM
|
#13
|
Montana Master
Join Date: Sep 2006
Location: Casa Grande
Posts: 5,369
M.O.C. #6333
|
Murf, That's a dang good idea...Are they available at Lowes/Home Depot????
|
|
|
05-09-2010, 07:32 PM
|
#14
|
Seasoned Camper
Join Date: Apr 2010
Location: Panama City
Posts: 76
M.O.C. #10337
|
Quote:
quote:Originally posted by exav8tr
Murf, That's a dang good idea...Are they available at Lowes/Home Depot????
|
Yes, they are. About $15 each last time I bought one.
When you wire it up look at the instructions one set of leads will cut power to down stream outlets, the other will leave it on.
But be careful with that because in my trailer there is at least one kitchen outlet downstream. You could install a second GFCI there.
|
|
|
05-10-2010, 01:43 AM
|
#15
|
Montana Master
Join Date: Dec 2007
Location: Kansas City, Missouri
Posts: 2,727
M.O.C. #7992
|
Not an electrician but just thinking out loud. I think I would leave anything on that slide on the GFCI. My thought is if the wire feeding the slide is moving everytime the slide is operated it has a higher potential for a rub or a nick in the insulation of the wire. The GFCI is going to give you an earlier warning sign of this problem. Perhaps someone with more expertise in this area can clarify. Jim
__________________
2006 3000RK
2009 Ram 2500
|
|
|
05-10-2010, 01:45 AM
|
#16
|
Montana Master
Join Date: Dec 2007
Location: Kansas City, Missouri
Posts: 2,727
M.O.C. #7992
|
Quote:
quote:Originally posted by bigmurf
I replaced the CFCIs with new units that have a red LED to show when they are tripped.
|
Murf, As Phil has already said that is a great idea. Just bought one at Lowe's the other day, $15. Jim
__________________
2006 3000RK
2009 Ram 2500
|
|
|
05-12-2010, 03:02 AM
|
#17
|
Montana Fan
Join Date: Mar 2006
Location: Manakin-Sabot
Posts: 371
M.O.C. #5540
|
We just finished a factory tour here in Goshen. I suggest you send your comments about wiring to them.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
Similar Threads
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
Living Room slide
|
mont |
Montana Problems, Problem Solving & Technical Help |
2 |
07-10-2008 05:14 PM |
living room slide
|
tom41 |
Montana Problems, Problem Solving & Technical Help |
12 |
01-04-2008 11:11 AM |
living room slide
|
Dont |
Montana Problems, Problem Solving & Technical Help |
1 |
01-13-2007 03:26 PM |
Living room slide
|
Bill DeMeulle |
Montana Problems, Problem Solving & Technical Help |
5 |
04-25-2005 05:58 PM |
Living with slide's
|
Montana_2785 |
General Discussions about our Montanas |
12 |
01-02-2005 08:26 AM |
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|