Schwintek Controller Location on 2022 295RL High Country

[nzak]

After a 600 mile trip home,went to open bedroom slide and only goes out about 3” and stops. When bringing it back in left side has a grinding noise trying to find controller to see if it has any codes
Don’t want to try reset process because of grinding. Trailer is plugged into shore power. 22 295rl high country

 

[C&P RV]

Should be mounted directly under the slide in the pass through just inside the baggage door

 

[nzak]

I have looked in front compartment, pass through, even took all the things out of the upper closet in slide out, nothing. Slide won’t go out far enough to lift bed to check there. Manual that came with trailer says it could be anywhere.

 

[C&P RV]

You almost have to lay on your back and look up just inside the baggage door on mine. Because that baggage door doesn't open flat against the side, it's a limbo move.

 

[nzak]

The only thing in that area is the pex and drain for the washer hookup. Next is the duct for heating. Nothing even mounted to the wall.

 

[nzak]

I am thinking of trying to disconnect the motors and having 2-3 friends help me push it out so I can raise the bed platform to look up by head of bed.

 

[Mikendebbie]

Screen shots below from a sales video for a 2022 295RL…
The Schwintek controller is mounted to the ceiling of the pass-thru basement.

 

[Daryles]

Check the gear racks (rails).
Look for damage. If so, you will need professional help.
I have to push ours out the last 6".
Scheduled for repair at Affinity in September.

 

[nzak]

Finally found it, was mounted in front compartment above the solar panel prep black box. Have to take cover off of prep box to get to it. Need to turn everything off before I can take it down to read it. Then turn everything back on.