Lug nut size for 2022 HC 295RL

[flyingjack]

My promised 3 day axle alignment will actually be 10 days due to shop personnel no show. Found this out after I delivered 5er. Anyway, I'm also getting new tires installed after the alignment and want to get new closed end lug nuts. BUT, 5er is 30 miles away so I can't measure OD. Does anybody know for certain what size lug nuts or OD of wheel studs my model has so I can order ASAP. We're getting too close to our departure date for UT and the PNW to have very many more delays. As usual, I should have started sooner.
Thanks for any help.
Jack

 

[Rene T]

Wait till you go camping then take one off and take it to a parts store. Then buy an entire set and change them out one for one. Then take it back to the garage and ask them to torque them again.

 

[RMcNeal]

If memory serves, there are either 1/2 inch or 9/16 inch studs depending on your axle rating. I think the 7K axles all have 9/16 studs. The lower weight rated axles could have 1/2 inch.

 

[flyingjack]

Thanks for the replies; I had tire shop put the original nuts back on and then I checked torque when I got home=about 80% correct with a couple pretty low-not terrible. I'll wait until we get back from trip in mid July and swap them out as suggested. Brakes and wet bolts will be due for inspection as well.

 

[DutchmenSport]

The lugs on my Montana are 3/4 inch. This is also the same size bolt used to secure my Lippert 6 point leveling system jacks. I bought that socket and a breaker bar specifically so I could move the jacks up. It turned out, the same socket fit the lug nuts on the tires. So, I decided to keep the breaker and the socket as a dedicated tool specific for tire removal. It's worked great, and I've used it a few times over the last 6 years.

 

[Carl n Susan]

They are 1/2" x 20 lugs on my 7K axles. But I don't have a HC and while, I would wait for an owner of one to verify, I would be surprised if your lug were not 1/2" x 20

 

[Rene T]

The lugs on my Montana are 3/4 inch. This is also the same size bolt used to secure my Lippert 6 point leveling system jacks. I bought that socket and a breaker bar specifically so I could move the jacks up. It turned out, the same socket fit the lug nuts on the tires. So, I decided to keep the breaker and the socket as a dedicated tool specific for tire removal. It's worked great, and I've used it a few times over the last 6 years.

Is that the diameter of the stud or the size of the socket?
A 1/2” bolt takes a 3/4” socket

 

[flyingjack]

Thanks, I just put originals back on and will replace in July when back from trip and can remove one, confirm size and get a set.
Thanks to all.

 

[DutchmenSport]

Is that the diameter of the stud or the size of the socket?
A 1/2” bolt takes a 3/4 socket

The socket.