ChuckS

I swapped out the Touch Pad today. I did kill the 12V and 120V power so there was no chance of any electrical surprises. The first trick...

Broken rivets off the guide block gibs... https://lci-support-doc.s3.amazonaws.com/assemblies/slideouts/ccd-0002715.pdf

Also since your Alpine is a 2020 it’s a good bet the roof and side wiper seals are puckered and need replacing .. Very easy to remove...

On each of the main slides down toward the bottom edge of the outside wall is a strip of metal.. this is a “drip strip” .. if the bead...

Welcome to the group.. you will find lots of useful info and help here.... Your Bullet Premier should have Dexter EZ lube hubs already (...

There is no way to KNOW what may or may not break due to many variables that have been mentioned previously. The maintenance and care...

Again, welcome to the forum... You mentioned in your post about your 2014 Alpine: " this was a 100k fifth wheel when bought new l...

My Alpine is a 2014... Currently ... knock on wood all appliances, slides, hyd leveling system work as new.. Upkeep is "key" to...

My bet is that new fan motor will solve your circuit breaker popping issues as well... I would use a simple clamp on amp meter and...

Short answer: your current part #421484 is still the correct, current replacement — it has not been superseded to a new number. What...

IMO I would not buy anything directly from Lippert unless it was the only place that had what I needed.. Either the ones off Amazon or...

I bought a set of S637's last fall on Amazon and they were 6 moths from manufacture. Not in the least concerned as they were not mounted...

Email I received today regarding inquiry of the new Sailun S637T HD versus the original S637 series tire , date manufacture being seen...

Dometic does provide a Penguin II to Freshjet 5 conversion guide.. the confusing issue is at the top of the guide it shows some Freshjet...

Actually Dometic should fix the issue of non compatibility between the new Fresh Jet 5 unit and exisiting controllers installed on the...