This is the MOR Ryde IS system'
We have a post in "repairs & service" Topic "Need information."
Mor Ryde is very concerned about our problem of not being able to remove or install the Galley tank or any tank because of the IS suspension restricting access to the tank.
they did offer that we bring the Montana to the MOR ryde plant so they could see and correct the problem however our dealer has the expertise to remove the system and replace it. Mor ryde has asked us to come to the plant when we can so that can look at the issue and correct it. This is a very expensive job.
The issue is that with the Mor Ryde system we lost 6 to 8 inches of clearance and the galley tank can not be removed without dropping the Is system which is no small task.
Mor Ryde says they are unaware of that problem but they are concerned.
Will all those who have the Mor Ryde IS system installed take a look under there and determine if the tank can be removed. That cross beam is very close to the underbelly. The system is bolted on and stitch welded.