OK, we will put this to bed. The OEM screws are #8. They extended about 3/4" below the base of the table, figure compressed carpet @ 1/4" that gives you 1/2" of bite into 1" of plywood. So with my 250 lbs pushing on one end of the table while trying to retrieve a adult beverage stored behind the table, well the screws pull out.
I considered gluing a dowel into the stripped hole, but that would only delay the known results. Refer to theory mentioned earlier.
So, using previously mentioned theory, I obtained some #14 wood screws. I found 2 1/2" to be the correct length for this project.
The original screws are recessed .35-.39" below the surface of the table feet. By going with 1/2" longer screws that gave them a bit more purchase into the floor. I beveled the OEM hole to fit the bevel head of the new screws and screwed it down into the existing holes. They tightened up nicely.
If they pull out again, I'll fill the holes with a product like Git-Rot or a liquid epoxy, screw it down and let it set up.
Jim
__________________
2012 Ram Laramie 3500 DRW 4x4 3.73 Tow Max Pkg B&W Companion 60 gal RDS aux fuel tank. 2014 Montana 3150RL, 2 A/C's, Leather, 6 Point Jacks, Splendede WD2100XC, Mor/ryde X-Factor, Duravis 250 tires with TST 507RV monitors. 2 x Honda EU2000's