Problem with Lippert control module

[trophyhusband]

The Lippert control module for my 345dbq was acting up on me so I ordered as new one. The new one is a little different and I'm hoping someone can help me out a little.

The old one has nine output terminals along the left side with the following labels from top to bottom: Light, LG/STB FT, STB, Room, AWG.

The new one has 10 output terminals along the left side with the following labels from top to bottom: Light, Awning, E Aux, Room, Landing gear, H Aux, -Pump, +Pump.

So far I've hooked up wires to power in, manual switches, light, and awning. Everything now works using the manual switches and the light works with the remote. Now I need to get the awning, landing gear, slides, and stabilizer jacks to work using the remote.

If anyone is familiar with this please chime in.

Thanks

[Irlpguy]

There is a LED on the right side of the control, does that come on when you turn your remote on. Check the battery in the remote, that is often a problem. The LED must come on to operate from the remote. Your control is the same as mine and I expect it must have the "Manual Switches" + & - above your other noted terminals.

Make sure the controller is grounded to the frame, some have solved a problem by adding an additional ground.

[Irlpguy]

If you are near the Controller and turn on the remote you should also be able to hear an audible click as the relay comes on.

Below the LED is a button that can turn the controller off, it might be a reset button.