Adjusting hydraulic slide
Is there a procedure or write up about adjustments on a hydraulic slide. My dining room slide seems to be out of adjustment. It opens and closes well but when closed the front of the slide seems to stop first at the top and causes the slide to lift up and the floor is about an inch or so higher then the rear of the slide. After being closed the rubber gasket that runs from top to bottom and is compressed is now open at the bottom about 1/2" and tight at the top. The rear gasket is tight top to bottom. Also is there a way to stop the front bedroom slide from moving while operating the rear slide? I would like to operate the slides independently rather then being in sequence, bedroom first then dining room next opening and then same sequence closing.
__________________
2003 Holiday Rambler Navigator 43PKD 500HP 11L Cummins ISM
2005 Keystone Montana 2955RL (sold)
1999 F350 SC (sold)
|