Pinbox and Pullrite

[Zilos6]

Greetings all,
Brand new to the RV world and this forum, but have a question I am hoping somebody on here can answer for me. I have a new Montana 3120 RL and recently had a Pullrite 2700 installed in my truck for it. I have to install a Capture Plate on the pinbox on the trailer. The one they gave me seems to be the wrong one based on the installation instructions. I looked at the compatibility chart that Pullrite puts out and my pinbox doesn't match any of those measurements. When I measured the pinbox using the Superglide instructions, it measured 12 inches wide and 5 inches from the front edge of the pin to the leading edge. Based on my lack of knowledge, I don't want to make a mistake and install the wrong one. They gave me the 3365 and based on Pullrites information, I should be using the 3366. If anyone has familiarity with all of the above, can you please help an uninformed newbie? Thanks!

[DQDick]

The best thing to do is to call Pullrite. They have great customer service and will give you the correct answer and figure out how to help you.

[rohrmann]

Looks like the 331760 is the proper capture plate according to their fitment chart. https://www.pullrite.com/fit#QCCP-fit


It doesn't look like either one of the capture plate numbers you quoted will work with the Road Armor pinbox.

[Zilos6]

Originally Posted by rohrmann

Looks like the 331760 is the proper capture plate according to their fitment chart. https://www.pullrite.com/fit#QCCP-fit


It doesn't look like either one of the capture plate numbers you quoted will work with the Road Armor pinbox.

Thanks for the info. I finally discovered that after many many phone calls and have one coming in the next few days :-)