garbage draw

[SLC]

Hi

Both draw guides screws were loose on our trash draw.
On One side of the guide both ball bearings strips fell out
Can’t get both bearing strips in...any ideas??

The pic is the good side with the bearings in place.
The black strips which are the bearings in the pic fell out of the of the opposite side

Thanks!

[BB_TX]

I got them back in one of mine long ago. But too long to remember how I did it.
If it did it again I would just go to Home Depot or similar and get new full extension soft close slides.

[1retired06]

Agree, used much better quality slides from Lowe’s

[prndl]

You would get more interest if you had indicated you were talking about a drawer and not a draw. Sheesh

[Desert Rat]

What's a "draw"?

[fatcatzzz]

Took about a month for wife to decide she hated the garbage under the sink. So off to Home Depot I went. Bought two new European cabinet hinges and a install kit with a Forstner bit. Installed hinges on the door and now use this area to store pots and pans. We use a nice garbage can at the end of the bar. This works well for us.

[BB_TX]

Some people think that everyone in the US should speak and use descriptive terms exactly like they do in what ever part of the country they are from. It just ain't so.

I am guessing SLC is from Old Bridge, NJ.

[AZ Traveler]

A "draw" is the process Game and Fish uses to decide who gets big game tags.

[Texan]

If he were a 'Redneck' from Texas we would never understand him. You can only read between so many lines.

[prndl]

My comment was not to be mean. When I saw the post "garbage draw" I mistakenly thought the thread was about a parasitic electrical leak or draw which the OP referred to as garbage.
When I saw it was about drawer slides I thought spelling check was butting in and the OP did not see it before submitting. No offense intended.

[fatcatzzz]

And if he had used drawers, some may have though it as about pants used to take out the garbage. But then again I understood OP the first time.