Wizard mode on circuit panel

[LadyBeeRanch]

Can anyone tell me what is wizard mode on circuit panel for 2018 Montana Legacy. It appears to have a small red button in a recessed opening.

[Carl n Susan]

I posted this yesterday in answer to a similar question.


The following was copied from the Progressive Dynamics manual
=======================
The Charge Wizard Operation

While the built-in Charge Wizard automatically determines which operating mode is best suited to recharge or maintain optimum
battery condition, the Wizard Mode Button allows for manual override and has indicator light(s) to indicate the mode of operation.
NOTE: The Green LED on the left refers to the Charge Wizard - the Red LED on the right was for the Charge Sentinel (supplied on
converters built prior to year 2000)

BOOST MODE – Indicated by green LED remaining on. The output voltage is 14.4VDC to rapidly recharge the battery up to 90% of full charge.

NORMAL MODE – When the battery is between 50% and 90% charged, the green LED will flash once per second. When the battery has reached
90% of full charge the green LED will flash 2 - 3 times per second. In this mode the output voltage is 13.6VDC and the converter is safely completing
the charge of the battery.

STORAGE MODE – Indicated by green LED flashing every 6 - 8 seconds. In this mode the output voltage has been lowered to 13.2VDC, the RV
battery is fully charged and the converter is maintaining the charge.

MANUAL BUTTON - The manual button has been provided to allow the operator to temporarily override the converter (not recommended) or to
verify the converter is operating properly. For manual operation, Press and Hold the button. The indicator light will soon remain “ON” indicating Boost
Mode. Continue to hold the button and the light will blink rapidly indicating the converter is in the Normal Mode. Continue to hold the button until the
light blinks slowly indicating the converter is now in the Storage Mode. After the manual button is released the converter will stay in the selected
mode. When the battery charge status changes, the converter will return to the automatic mode of operation to prevent damage to the battery.