|
|
03-08-2019, 10:55 AM
|
#21
|
Montana Master
Join Date: Nov 2012
Location: Rancho Santa Margarita
Posts: 633
M.O.C. #13025
|
I haven't had any problem with shorts in the last 5 years since I replaced bulbs.
__________________
Russ and Linda, So. California
2004 Chevy Silverado 2500 HD, D/A, SRW, SB
2005 2955RL, Pullrite Superglide 16K hitch. Bridgestone Duravis R500 tires. EZ Flex Equilizers with wet bolts.EMS HW50C, Disk brakes
|
|
|
03-08-2019, 03:20 PM
|
#22
|
Montana Fan
Join Date: May 2006
Location: San Antonio
Posts: 429
M.O.C. #5757
|
Replaced all interior bulbs (12 v and 110v) with LED's two years ago. Can't get over how much more light we have and how much cooler the interior stays during warm times. Used the company in CA recommended on MOC. I use Southwest Wheel in San Antonio for a lot of "trailer" work-both on the Monte and two other trailers I own (not RV body stuff, but a lot more-they installed new Dexter Axles, the Level Up, and much more) and they have told me that for the exterior fixtures you are better off just replacing the fixture when you figure in fading from UV, etc. Just my $.02.
|
|
|
03-09-2019, 09:16 AM
|
#23
|
Montana Master
Join Date: Nov 2018
Location: Menifee
Posts: 1,109
M.O.C. #22986
|
Quote:
Originally Posted by rohrmann
It really isn't too hard to replace them, but beware they may not work properly once you have them installed if you use the wire colors that the rig was wired with. I got ours installed, then had to pull them out and change the connections, as they had the two filaments of the old lights backwards. I also installed two reds on both sides, replacing the backup lights with the second red lights, and then installed white LED light bars on the bike hitch bar for the backup function. These are the lights I used. https://www.amazon.com/s?k=SET+OF+2+...ref=nb_sb_noss
|
Did you use a resistor ? My understanding is you need to install a resistor to keep them from hyper blinking when the directional is on.. just curious its a upgrade I'm considering too
Tony
__________________
2018 3920fb 2020 GMC Denali 3500 4x4 Duramax, 10 speed Allison. LB SRW, Firestone air bags with Airlift wireless onboard compressor. Anderson Ultimate Hitch. MX4 folding cover. 50gal titan in bed transfer tank. Onan 6500 lp genset installed by me ! Had: 2 HF 3500 Inverters with Parallel Kit
|
|
|
03-09-2019, 08:00 PM
|
#24
|
Montana Master
Join Date: Oct 2012
Location: Box Elder
Posts: 4,700
M.O.C. #12947
|
Quote:
Originally Posted by Last2Die
Did you use a resistor ? My understanding is you need to install a resistor to keep them from hyper blinking when the directional is on.. just curious its a upgrade I'm considering too
Tony
|
No resistor needed. I think the only time you might need something different would be on an automobile that has an old fashioned light duty blinker relay. With the heavy duty relays in these trucks, that are capable of handling extra signal loads, they don't have a problem with the LED units.
__________________
Bob & Becky
2012 3402RL
2012 Chevy 2500HD D/A CC 4WD
|
|
|
03-10-2019, 06:36 AM
|
#25
|
Montana Master
Join Date: Oct 2017
Location: Bastrop
Posts: 2,892
M.O.C. #20753
|
Quote:
Originally Posted by rohrmann
No resistor needed. I think the only time you might need something different would be on an automobile that has an old fashioned light duty blinker relay. With the heavy duty relays in these trucks, that are capable of handling extra signal loads, they don't have a problem with the LED units.
|
Yes, but the computer may mis-diagnoise a bulb out and give you the hyper-blink to tell you. Is what he is referring to.
Ours has factory LED tail and turn and we do not have hyper-blink. I do not know if they have installed a resistor.
__________________
Mocha, one-eyed toothless, hurricane survivor, Pirate dog
2019 20th Anniversary Edition 3701LK
B&W 20K for Ford OEM Puck
2018 Ford F-350 Lariat CCLB PSD DRW KJ5CQH
|
|
|
03-11-2019, 05:28 PM
|
#26
|
Established Member
Join Date: Oct 2018
Location: Dallas
Posts: 22
M.O.C. #22828
|
Quote:
Originally Posted by rohrmann
The tail lights are dual filament fixtures that are running lights as well as brake and turn signals, just like what are installed on all these rigs, whether they are the round style or some other shape and also incandescent or LED.
|
Is is there a cross reference from duel Filament bulbs to LED to order on line ?
|
|
|
03-11-2019, 10:00 PM
|
#27
|
Montana Master
Join Date: Oct 2012
Location: Box Elder
Posts: 4,700
M.O.C. #12947
|
Quote:
Originally Posted by sme1950s
Is is there a cross reference from duel Filament bulbs to LED to order on line ?
|
Not sure you can get a dual filament style LED bulb. More likely, the entire fixture should be replaced with one that has the LED's built in. The LED fixtures have the LED's spread fully around the lens area so you get the most light from the fixture.
__________________
Bob & Becky
2012 3402RL
2012 Chevy 2500HD D/A CC 4WD
|
|
|
03-12-2019, 07:20 AM
|
#28
|
Established Member
Join Date: Oct 2018
Location: Dallas
Posts: 22
M.O.C. #22828
|
Got a great deal on tail LED fixtures. Your comments are making it fun for me to work on our rig. Thanks
|
|
|
03-12-2019, 09:07 PM
|
#29
|
Montana Master
Join Date: Oct 2012
Location: Box Elder
Posts: 4,700
M.O.C. #12947
|
Quote:
Originally Posted by jeffba
Yes, but the computer may mis-diagnoise a bulb out and give you the hyper-blink to tell you. Is what he is referring to.
Ours has factory LED tail and turn and we do not have hyper-blink. I do not know if they have installed a resistor.
|
I'm really thinking that the manufacturers of these LED units have done whatever is needed to compensate for these issues, as there is a circuit board in these units that the LED's are attached to, so there are probably any necessary other components to make them work properly.
__________________
Bob & Becky
2012 3402RL
2012 Chevy 2500HD D/A CC 4WD
|
|
|
03-13-2019, 08:49 AM
|
#30
|
Montana Master
Join Date: Jun 2014
Location: Vancouver Island
Posts: 894
M.O.C. #14417
|
Bob. Your link showed rectangular lights. Is that what you have?
__________________
Lenny and Ros
2012 Montana 3400RL,680 Watts Solar,4xT-105 Trojans,GP-ISW2000-12 Inverter,Trimetric 2020, EMSHW50C
2009 Chevy Silverado 3500 LTZ Duramax 4x4 CC Dually, Banks Speed Brake
|
|
|
03-13-2019, 08:58 AM
|
#31
|
Montana Master
Join Date: Jun 2014
Location: Vancouver Island
Posts: 894
M.O.C. #14417
|
__________________
Lenny and Ros
2012 Montana 3400RL,680 Watts Solar,4xT-105 Trojans,GP-ISW2000-12 Inverter,Trimetric 2020, EMSHW50C
2009 Chevy Silverado 3500 LTZ Duramax 4x4 CC Dually, Banks Speed Brake
|
|
|
03-20-2019, 11:18 PM
|
#32
|
Montana Master
Join Date: May 2017
Location: new caney
Posts: 1,050
M.O.C. #19873
|
This is the style I used but I think I got them from Napa and paid a little more but I was wanting to make sure they were very close to fitting and I still needed a Dremel to hone the hole out a little.
|
|
|
03-31-2019, 10:07 AM
|
#33
|
Montana Fan
Join Date: Sep 2018
Location: Mountain Home
Posts: 121
M.O.C. #22661
|
Panic light lef
Does anyone know what LED light bulb is used to replace the panic light on a Montana High Country 380TH?
B Richey
|
|
|
04-07-2019, 02:56 PM
|
#34
|
Montana Fan
Join Date: Feb 2009
Location: Redlands
Posts: 460
M.O.C. #9135
|
__________________
2011 3150RL
|
|
|
04-08-2019, 04:51 AM
|
#35
|
Established Member
Join Date: Oct 2018
Location: Dallas
Posts: 22
M.O.C. #22828
|
just used existing wire and sealed the pockets no blinker issues off you go. Nice change out, looks better than the original. Thanks for sharing.
By the ocean my kine of white noise. I have a hard time finding a space near a lake.
S
|
|
|
04-08-2019, 10:58 AM
|
#36
|
Montana Master
Join Date: Oct 2017
Location: Bastrop
Posts: 2,892
M.O.C. #20753
|
Nice..
__________________
Mocha, one-eyed toothless, hurricane survivor, Pirate dog
2019 20th Anniversary Edition 3701LK
B&W 20K for Ford OEM Puck
2018 Ford F-350 Lariat CCLB PSD DRW KJ5CQH
|
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
Similar Threads
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
LED lights
|
shovelhead86 |
Additions & Improvements |
5 |
06-12-2016 02:18 PM |
Outside Lights
|
emptynest |
General Discussions about our Montanas |
9 |
11-15-2013 06:48 AM |
Lights
|
kjansen |
General Discussions about our Montanas |
6 |
02-16-2012 01:26 PM |
LED Lights
|
JMG |
Boon-docking |
1 |
03-15-2009 10:38 AM |
LED Lights replacing 12V inside lights?
|
danlinserv |
Additions & Improvements |
2 |
07-05-2008 06:44 PM |
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|