2018 Montana kitchen slide binding pop noise jumping gears
Hello everyone, new to this forum, hopefully we can help either with my experience and along the way find the solution to my problem.
Went to slide out the driver’s side kitchen slide, it is of the rack n pinion hydraulic variety, made a loud clock noise a couple of times which indeed jumped teeth and became out of timing and alignment, and at the end of the full open position, the front part of the slide was not all the way open/out. I did some research, replaced both gear bearing pack, retimed and realigned, greased the all The contact area at the gear square tube minus the actual gear area, I even readjusted the square tube right where the bearing pack mount as it was crowned and read that, that will cause binding, after all these repairs nothing made a difference.
If there is anyone that has experienced this condition and if you know the repair please share your experience I’d would appreciate it.
Thank you.
Good weekend Montana family.
|