|
Brake Magnets
Well the Al-Ko grease fitting strikes again. Last year I did not pack my bearings my hand just raised each wheel and "slowly" using hand grease gun applied grease until it came out the frontand axel fitting. Well this year I checked and sure enough I had blown the rear seal on one axel. I installed new back plates and brake assemblies and my question is. Does the poloarity of the wires connected to the brake magnets matter? I can poll the wires comining from the axel but the magets only have white wires with no markers. I feel with DC it won't matter but does anyone know for sure?
|
Linear Mode
