Bedroom Slide lubrication

[jmd80ta]

I am trying to figure out how to lubricate the Bedroom slide on my unit. I have no problems with the living area slide as everything is exposed from the outside. But the bedroom is covered with the black plastic panel and nothing is exposed. Is there access on the inside for this and if so how?

[lawrenceb42106]

If it is like ours, you raise the bed and remove 4 screws that hold the bottom in in the storage below the bed. Underneath you can get to every thing on that slide.

[jmd80ta]

Thanks, I will look into that this weekend.

[dieselguy]

I've been in there ... nothing to lubricate. The head of the bed is screwed to the slide floor and the foot rolls over the carpet on plastic roller wheels. The hydraulic cylinder which is self lubricating, is fixed to the bedroom floor and its ram bolts to a flange on the bedroom slide floor ... no metal on metal sliding surfaces.

[hazmic]

My slide out has steel tubing that the slide goes into. Where the tubes slide into each other is what you need to lube with grease-less lube. There should be one on each side. Also while in there check and make sure that the bolts are tight and everything looks OK. No seal leaks on the cylinder. This was told to me by Dale who still might be on this form and he worked for Lippert who makes the slide outs. He recommended to do this at least once a year. You do what you want as it is you camper.