LED Lights

[bsmeaton]

Dennis,

Any reason the rear light strip wouldn't work on the Monty? Attached to the rear jacks along the bottom?

Just thought it might improve over those single bulb chev tailights they insist on using.

[Illini Trekker]

No reason It comes with stick on pads, which I didn't use and choose to use screws. Brad I think I'd use a light angle iron across the back then screw to that. It would look GOOD! I now have one LED light on each side near the bottom.

[bsmeaton]

I think you're right Dennis. After looking at my photos again, the jacks may be too far forward and I don't think you could see them. A small angle iron at the back cowling screws would work good. I removed the tailight and there is certainly no problem getting the wiring down there. Huge cavity in the back.