X Factor

[NCFischers]

I installed the X Factor this afternoon. I ordered the solid one piece unit from Mor/Ryde. I'm glad that I did. The bottom of the suspension housings was about 1/4 inch further apart than the top. I found no obvious damage or broken welds. After the X Factor was installed, there is no longer a difference in width. I'll keep an eye on the welds but I feel a lot more confidant in the strength of the suspension.

[kingdaddy]

I am going to be doing this in the next week or so...so you just installed one in the center I assume? What do you think about the full set? Overkill?
Do you just give them the width dimension and then they fab it up for you or is it pretty much standard width?
I agree that I will feel more confident on the strength especially every time I have to make a tight turn.

[NCFischers]

I just installed the center one. I might do the others at a later date. I ordered it from Mor/Ryde. They knew the length, it's pretty much standard. If I installed the two piece adjustable one, I might not have noticed the difference in width and wouldn't have been able to correct it.