|
07-15-2010, 04:06 PM
|
#1
|
Montana Fan
Join Date: Feb 2010
Location: St. Clair Shores
Posts: 389
M.O.C. #10151
|
Big Step!
We have it! Our 2011 Silverado one ton is here! It is an amazing truck. Walt is in Big Boy Heaven! Lynne, well, not so much.
Here is the hassle. It is a gorgeous vehicle with one problem from my point of view. Now, I'm an old, fat lady with a bad knee. Stepping up into the truck or down from it is ONE BIG STEP! It's like climbing the face of a mountain to get in and an attempt at a controlled fall or a giant leap of faith to get down! We DO have the running boards and they sure are pretty. However, they are installed (per specs) right under the door edge so they really don't do much to shorten the climb or fall.
Am I the only one with this problem? Has anyone out there found a solution or have any suggestions? I sure would appreciate it!
Thanks, Lynne
|
|
|
07-15-2010, 04:26 PM
|
#2
|
Montana Fan
Join Date: Feb 2004
Location: Nampa
Posts: 140
M.O.C. #1027
|
Lynne,
We have dealt with the same situation since we took delivery of our 2003 GMC 2500HD 7 years ago - short legs, bad knees and all!
Our solutions - 1st of all, I chose the aftermarket Weston Nerf style step bars - mounted down from the cab - with just enough room to be useable to step up on. This style bar looks great and is very functional.
Secondly, and probably most importantly, we carry a single step Rubbermaid step - with a piece of 1/4" rope attached thru a hole drilled in one side. The rope is long enough - with a loop tied in the end - so it can be slipped onto the door handle and used to retrieve the step after you are in the cab. Just set the step over the seat into the back seat for use next time - works like a charm - cheap insurance against a twisted knee or worse.
Ed Benson
|
|
|
07-15-2010, 04:33 PM
|
#3
|
Montana Master
Join Date: May 2003
Location: New Bern
Posts: 4,295
M.O.C. #311
|
I did the Nerf bars and also picked up one of the folding plastic steps form Camping World or Wall Mart. Both work well to help.
Good luck and congratulations on the new truck.
|
|
|
07-16-2010, 12:53 AM
|
#4
|
Montana Master
Join Date: Aug 2008
Location: New Bern
Posts: 4,387
M.O.C. #8728
|
I use the step stool when I take my 4'10" mother in the truck. Her knees are also bad and this works for her.
|
|
|
07-16-2010, 05:30 AM
|
#5
|
Montana Master
Join Date: Aug 2004
Location: Fallon
Posts: 6,064
M.O.C. #1989
|
We purchased after market running boards that are not the tube type but flat and wide. We also use the folding step stool. It really is the best solution. The night we purchased the truck, we were taking it home. The running boards were not installed yet. I couldn't get in the truck and the dealer did not have any type of stool so they finally found a box for me to stand on!
Happy trails...................
|
|
|
07-16-2010, 06:54 AM
|
#6
|
Montana Master
Join Date: Jun 2006
Location: Grand Blanc
Posts: 2,508
M.O.C. #5965
|
Like Sue, we have the wide flat running boards and also, when Carol had her knee replacement, we additionally used a folding step stool. In total,it worked like a charm, bad knees and all.
|
|
|
07-16-2010, 07:17 AM
|
#7
|
Seasoned Camper
Join Date: Feb 2003
Location: Clovis
Posts: 91
M.O.C. #183
|
This is one way to gohttp://www.ultimateautoaccessories.com/Category%20Pages/Power_Step.htm
|
|
|
07-16-2010, 07:40 AM
|
#8
|
Montana Master
Join Date: Sep 2006
Location: Casa Grande
Posts: 5,369
M.O.C. #6333
|
priceml, that is one sharp looking step. Wish I had seen them earlier. I had the Westin Tubes installed. Serves the prupose for much less dinero....
|
|
|
07-16-2010, 08:23 AM
|
#9
|
Montana Master
Join Date: Mar 2007
Location: Chico
Posts: 641
M.O.C. #6933
|
Check out Amp Research retractable running boards. I have them and love them.
|
|
|
07-18-2010, 09:59 AM
|
#10
|
Montana Master
Join Date: Apr 2007
Location: South Shore
Posts: 6,009
M.O.C. #7110
|
We had custom running boards on our previous truck it that came with it. They went bad and had to be replaced. I put on the nurf running boards and never did like them because they were too high and close to the door. I tried to get someone to mount them lower but couldn’t find anyone that would do it. I like a wide flat step like the one we now have on our Ford. If I had to do it again I would consider the step mentioned here if I couldn’t replace it with what I now have.
__________________
2011 GMC 4X4 dually CC, 6.6 Duramax with Allison Transmission. Formally 2001 Montana,2007 3400RL Montana, presently 2018 3401RS Alpine.
|
|
|
07-18-2010, 06:32 PM
|
#11
|
Montana Master
Join Date: Jan 2009
Location: Land O Lakes
Posts: 932
M.O.C. #9053
|
We had factory installed retractables on two previous Lincoln Navigators. Never had any trouble, save a loose bolt one time. They worked great. Not availabel as an option on the F350, though, or we would have got 'em!
__________________
Walt and Carol Ashley, with fond memories of Bailey the Chesapeake! Land O Lakes, FL
2009 Big Sky 365REQ 10th Anniversary Edition
2008 Ford F350 King Ranch Super Duty
|
|
|
07-19-2010, 03:09 AM
|
#12
|
Montana Master
Join Date: Oct 2007
Location: Land O Lakes
Posts: 2,752
M.O.C. #7753
|
When we got the 06 Duramax we asked for Nerf style bars instead of the running boards. The last three vehicles we had that had running boards always loaded up with mud, sand and gravel no matter where we went. It always looked terrible and we ended up dragging most of it into the trucks... Dave
|
|
|
07-19-2010, 02:09 PM
|
#13
|
Montana Master
Join Date: Aug 2008
Location: Shelburne
Posts: 688
M.O.C. #8693
|
I've taught people to use the opposite foot first when getting in. Not intuitive, but my 85-year-old aunt did it and sailed in and out.
|
|
|
07-20-2010, 02:08 PM
|
#14
|
Montana Master
Join Date: Mar 2010
Location: Land O Lakes
Posts: 2,783
M.O.C. #10246
|
We have stock running boards on our truck...fine for me, but wife needs a modified step stool (plastic stool with a hole drilled in the center with a rope through the hole to facilitate retrieving the stool after in getting in the cab. Works for us.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|