Lippert hydraulic valve wiring

[SHANKSTER]

I disconnected all six wires to my hydraulic valves and forgot to take a picture. Here is one from the internet for reference. If anyone has a 2019 and can send me what goes where or a good picture that would be great. Got all jacks working but can’t seem to get slide out wiring hooked up right. I switch it around and sometimes have my leveling control panel moving my slides out lol. Help!

[scottz]

Welcome to the forum. Here you go, hope these help. Let me know if you need different shots. My 2017 3160RL should be very similar to your 3120RL.

[SHANKSTER]

That actually helps a lot. I thought one of the valves was for the front landing gear. Assuming that is somewhere else. So I see front to back: (blue, white), (purple, white), (grey and white with grey stripe)

[scottz]

I think the rear valve is for the hydraulic rooms, the center goes to the left rear jack and the front valve goes to the right rear jack. I believe the rear and center jacks operate off the same hydraulic line. The front jacks line comes off the end of the manifold and the control valve is located elsewhere. Attached is a basic drawing; no guarantee on accuracy.

[Arkware]

The control valve for the front jacks is on top of the ODS (off door side) jack.

[Daryles]

Here's another one.
I'm going put better labels on the wires and on the valve.

[ChuckS]

The wire color code for the Lippert 6 point Hyd level up and hyd slide control system has been standard for many years

These 3 images should give you all the info needed to make sure all the hydac valve coil wires are correct, pressure switch, extend and retract signal, etc