Anti-Siphon Valve on 2011 295RKD
I have a 2011 Montana Mountaineer 295RKD. I hoping that someone with a like rig or has knowledge of this model rig can help me out. I want to see if my calculations on the location of the Anti-Siphon valve are correct and if there is an access port to the valve that I have missed so I don’t have to cut a new one.
From information I got from the MOC forums I found that you can locate the general position of the Anti-Siphon valve by following the black tank flush water line from the connector. I did that. The picture P1 shows the water line leads to the back side of the equipment compartment.
Taking careful measurements, I measured from the location of the where I found the water lines (water line from black tank connector and water line to black tank) and found where I believe the valve is located in the 295RKD.
Looking at a layout of the 295RKD, the suspected location of the valve is in the wall between the entryway cabinet and the toilet, picture P2. I can find no access panel anywhere in that area. I have checked the walls, cabinets and entertainment center area. Does anyone have any specifics on the exact location of the Anti-Siphon Valve on a 2011 295RKD?
From my calculations, picture P3 shows where I estimate the valve should be located, give or take. I think it is located in the wall between the entry cabinet and toilet. The tape in the picture is at the height of the toilet. Any help or suggestions? I hate cutting out a section of wall and finding I am in the wrong location.
|