I pulled all the carpet from our Montana yesterday - main floor and slides. (I’ve yet to put the carpet from the bedroom/bath upstairs) I’m going to put a sheet of 5mm plywood on the slide floor to bring the vinyl plank up to near the top of the plastic runner on the slide. It will leave about 1/2” of the runner showing but that’s okay with me.
The thing I’m trying to figure out is how to cover the heads of the carriage bolts and the 1/4” rise from the main floor next to the slide out. I may just run the plank flooring up to the bolt heads and then glue down a piece of trim or transition to cover them and little strip of plywood next the runner. Or add a one inch strip of 1/4” plywood along the main floor edge where it meets the slide out runner. I could cut the underside of the plywood where it goes over the carriage bolt heads, and then glue down either transition or flooring over it.
Dave in AZ
2008 Montana 3400RL
2008 Dodge Ram 3500 Diesel Dually