Greasing 350RL Landing gear

[Husker92]

Can anyone provide suggestions on how to grease the front landing gear of a 2015 305RL?

Thanks for your advice

[1retired06]

If you have the traditional ventura landing gear with motor drive, on my previous units, the top cap would snap off and you could spray white grease down the shaft. Someone on this forum indicated there were zerk fittings on his, never on mine. Some silicon spray on the legs themselves, moving the legs up and down while hitched is also helpful.

[Twopetes]

Agree with 1retired06

No zerks on our 15 HC 353RL. I just spray down the inside to lube the screw. And the silicon on the outside is a good idea. I also silicon lube the pins and extensions on the bottom. The pins have a tendency to hang up part way out. Also, running the legs up and down when hooked up is a good idea.