Low voltage reading on Level Up

[napria]

While we were out this past week our Level Up would start to level, then stop and give a "Low voltage" message. Any ideas why?

[rohrmann]

If your battery(ies) are good, maybe you haven't made the upgrade from the 40 Amp auto reset breaker to an 80 Amp breaker from your battery to the hydraulic pump. This is a known issue, and is an approved fix for this issue from Lippert.

[jlb27537]

Is your battery disconnect switch on? If the switch is off, everything in your rig will work properly, but the battery will not charge when plugged in.

I did that once.

Jim

[Irlpguy]

This is one of the "error messages" that says exactly what it means. You have low voltage to the system. You must determine what is the cause of the low voltage, bad/low battery, poor connections to either power or ground.
The level up works regardless of what position the disconnect switch is in, however the battery will not receive a charge if the switch is in the off position. (you can remove the key only in the off position)

Here is some very good information for you when having any problems with the level up system: http://lci1.com/assets/content/suppo...ting_Guide.pdf

The battery/batteries must be in top condition to operate the hydraulic system as it has a high current draw. If you don't have two batteries I would recommend you add an additional battery.

Good luck

[napria]

Very helpful information! Once again, the MOC forum comes through. Thank you so much!