Vinyl trim molding insert

[Baldicon]

Anyone out there used this vinyl trim molding inserts? I ordered the samples, and it looks much thicker that what came on the trailer. It is a bit pricey.

https://www.amazon.com/LPC-Camper-Tr...69&sr=1-5&th=1

[RMcNeal]

I ordered 2 rolls. Haven't put it on yet. The original stuff was destroyed in the first year from sun, I guess. It was very thin and cheap. I didn't pay any where near that much though.

[Baldicon]

Originally Posted by RMcNeal

I ordered 2 rolls. Haven't put it on yet. The original stuff was destroyed in the first year from sun, I guess. It was very thin and cheap. I didn't pay any where near that much though.

That price is for a 100' roll. I'll wind up replacing all of it in time.

[RMcNeal]

Well that's a bit better. I think mine were 15 or 20 foot rolls. I paid about $25 for the two rolls

[Rickatom]

Does montana use the .75 or 1 in strip?

[Baldicon]

I used 3/4".

[Daryles]

Rickatom,
I ordered this one and the end caps to hold it in place.
It's thicker than the original but not as thick as the OPs.
As I did it, I removed each screw, injected a little sealant into the hole and put the screw back down to prevent any water intrusion.

Automotive Authority Black Vinyl 1" Insert Molding Trim Screw Cover RV Camper Travel Trailer (Black, 100 ft) https://a.co/d/ay788gK

Temple Products 10 Pack RV Camper Trailer Aluminum Black Flat End Cap for Trim Molding 1" & Screws https://a.co/d/iIXhyat