Broke Corner Moulding

[BobbyJ]

I had a minor backing incident and cracked a rear corner moulding. It is a hard plastic corner bracket that makes a 90° "L" shaped curve (one leg is longer than the other). Bottom rear corner, passenger side.


I've tried several local dealers with no luck. One actually GAVE me a possible replacement (extra they had laying around) but I need the mirror image. The short leg of the L goes up the side/back corner, the long side lays down on the bottom/rear corner. Photo attached.


Any ideas how to find a replacement? I'd like it to fit as original. I don't want to have to re-do the entire rear end to get the trim to cover completely.


Any ideas for even a temp fix? Had duct tape on but that's no good.


Thanks.
Bob

[dhuhn]

You can try trekwood.com they have lots of part but not cheep

[twindman]

I also need this exact piece on a 2013 Mountaineer. Keystone doesn't make or have it. So I am trying to get that piece from a 2020 High Country which is pretty similar except slightly textured and black. I figure I can paint it white and it will look pretty good.

[RMcNeal]

Eternabond would be better than duct tape, but good luck getting it off when/if you do find the part.

[BobbyJ]

Looks like trekwood.com has it. You're right: Not cheap.


Thanks for the replys.