Need Help Please - High Pointe Microwave

[eusefullone]

Hi everyone, I need an image of the "inside" of the control panel on a High Pointe Microwave. I replaced a door switch and unplugged all the circuit board plugs before taking a picture of where they plug back in. Most are obvious I know, but there are 3 black switches stacked in the middle (each with 2 prongs) and I am not sure which ones go on these. If you have a High Pointe model EC942K9E



Pretty easy to remove the top skinny panel above the door, then one screw at the top of the control panel and slide it up. Take a picture of the backside with all the plugs (especially those in the 3 black stacked switches) would be a huge help to me.



Afraid to power up the unit till i know these are correct or need to be changed.

[Daryles]

We HAD a High Pointe Model EC942KIW.
Replaced it with a Whirlpool. Got tired of replacing fuses and Door switches.
Hopefully the wiring is the same as yours, the model numbers are just a bit different.

[eusefullone]

Thanks Daryles! You saved the day for me! Most appreciate and I now have it working again. Thank you so very much for the picture.

[Daryles]

Glad I still had them on my phone. I thought I deleted them when we replaced it.

[eusefullone]

LOL, me too! Thanks again!

[Byron B]

Daryles, You probably still had them from when you replied and helped me!

[MUSKOKA1]

Greetings from Reddick, FL -

My microwave stopped working. There is power to the unit. From what I've read on this thread, a potential culprit may be the door switch. In fact, "lights went out" when I opened the door.

Question: Since I have zero experience with microwave ovens, is it worthwhile to call out a mobile tech to check it out .... or should I just replace the oven?
It's manufacture date is Dec '17.

Thanks much.

[Cherokee]

Just from my experience, I replaced the door switches also, it lasted about a month. I installed a Maytag non-convection MW and worked beautiful. High point isn’t the best quality.

[MUSKOKA1]

Thank you for your reply. I think you're spot on re: Highpoint quality.

Was the replacement you bought a good fit in the space or did it require mods to fit well?

Appreciate your inputs.

Best.

[Cherokee]

It was a perfect fit, I sold that fifthwheel so I don’t know the model. You will just have to replace the mount in the back where it sits on. Again, it was a Maytag.

[MUSKOKA1]

Originally Posted by Cherokee

It was a perfect fit, I sold that fifthwheel so I don’t know the model. You will just have to replace the mount in the back where it sits on. Again, it was a Maytag.

Thank you Cherokee. Very helpful inputs.
Safe travel.