Today's Project 03-21-2012

[Bill-N-Donna]

Today I repaired the harness under two slides for the wiring support. One of them was completely broken and the other one was well on the way. It’s relatively simple overall and pretty much self-explanatory.

[img] http://i1092.photobucket.com/albums/...s/03201210.jpg [/img]

[img] http://i1092.photobucket.com/albums/...s/03201211.jpg [/img]




This was the broken one

[img] http://i1092.photobucket.com/albums/...s/03211205.jpg [/img]



[img] http://i1092.photobucket.com/albums/...s/03211206.jpg [/img]



This was the other one on the back of the curb side slide.


[img] http://i1092.photobucket.com/albums/...s/03211208.jpg [/img]
[img] http://i1092.photobucket.com/albums/...s/03211207.jpg [/img]


The way the hinges and harness are positioned; when the slides are closed it doesn’t close the hinge but opens it more.

I was concerned that there might be a problem with the wires being too close to the bolts when the slides were closed so that’s the reason for the carriage bolts with the smooth end on the inside near the wires.

Her are a couple of pictures with the slides closed.

[img] http://i1092.photobucket.com/albums/...s/03211210.jpg [/img]

[img] http://i1092.photobucket.com/albums/...s/03211209.jpg [/img]


I was inspired with the idea from this thread.

Thanks again for the contributions from other MOC members!