|
Molding Insert Trim
Looks like we are going to be sitting put for the next ???? due to you know what. Tired of talking, reading, hearing about this virus running through the country right now. So while we have time, a lot of it, going to work on my list of projects. First off we are in a 2017 3820FK. In various places the exterior Molding Insert Trim is splitting, pulling out of the channel,basically just deteriorating. Found a replacement but I am thinking about just pulling it out and not replacing it. It "appears" to be there for aesthetics. Before I just pull it out and throw it away figured I'd take a minute (we have a lot of those now) to ask the brain trust for ideas. Have others had the same problem? Can I just pull it out and chunk it? My only concern is the screws I see under the trim. If I chunk the trim and DO NOT replace it, should I put a dab of silicone on the screws? Thanks Joe
|
Threaded Mode
