Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 

Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > MOC Technical Forums > Repairs & Service
Click Here to Login

Reply
 
Thread Tools Search this Thread Display Modes
 
Old 11-02-2024, 08:10 AM   #1
knightrider
Established Member
 
Join Date: Aug 2016
Location: virginia beach
Posts: 15
M.O.C. #18862
Refrigerator vent cover up

We changed out our gas/ electric refrigerator to 12 v. During one of the hurricane rain storms, water was pouring in RV behind microwave/ refrigerator area.
I’m not sure if it was through the upper frig vent or slide seal.
Since we changed 12v do we still need the upper vent or should we close the hole up?
 
knightrider is offline   Reply With Quote
Old 11-02-2024, 01:23 PM   #2
432bartman
Montana Master
 
432bartman's Avatar
 
Join Date: May 2020
Location: UPLAND
Posts: 1,334
M.O.C. #26190
I'm going through this same upgrade. From everything I've read, both vents get sealed up. Did you end up going with an inverter and everything else so you can operate the fridge while on the road?
__________________
2019 Keystone Montana 3560RL, 2020 Chevy 2500 HD, Firestone airbags, Air Lift wireless compressor, Curt gooseneck, 20K Reese Goosebox, TST-507, USMC combat vet & retired LEO. Robert, Anika, Breanna, Dylan (daughter-in-law Stephanie). & our Great Pyrenees Layla
432bartman is offline   Reply With Quote
Old 11-06-2024, 02:28 PM   #3
rickbecker
Seasoned Camper
 
Join Date: Jun 2013
Location: Quincy
Posts: 79
M.O.C. #13543
I just swapped out my gas Norcold for 12 volt from JC Refrigeration. According to them you can seal up the old vents. To not do so leaves your rig inside open to the out side and vulnerable to hot, cold and bugs!
rickbecker is offline   Reply With Quote
Old 11-06-2024, 04:01 PM   #4
scottz
Site Team
 
scottz's Avatar
 
Join Date: Apr 2017
Location: Colorado Rockies
Posts: 2,059
M.O.C. #19755
If you seal up the lower vent, how are you going to access the compressors, wiring, etc of the JC unit?

I think the upper vent could be closed up, but I have not done so. I'm not sure how to do it, perhaps something on the back of the existing covers which would have to remain in place to cover the openings.
__________________
Scott & Alta
2017 Montana 3160RL Legacy
2022 F-450 Lariat Ultimate
scottz is offline   Reply With Quote
Old 11-06-2024, 05:08 PM   #5
rickbecker
Seasoned Camper
 
Join Date: Jun 2013
Location: Quincy
Posts: 79
M.O.C. #13543
Quote:
Originally Posted by scottz View Post
If you seal up the lower vent, how are you going to access the compressors, wiring, etc of the JC unit?

I think the upper vent could be closed up, but I have not done so. I'm not sure how to do it, perhaps something on the back of the existing covers which would have to remain in place to cover the openings.
While the old refrigerator was out, I used 1 inch thick rigid foam insulating board and fitted it from just above the bottom vent to the top of the compartment such that it covered the top vent. I taped it in using aluminum tape around the edges. This left the bottom vent open to wire the frig after the unit was mounted back in hole. I also cut another piece of foam board just bigger than the bottom vent opening such that I could get back through the hole after I was done working in the compartment. I also used safety wire to make a U clamp. It poked from the back side out to the front such that I could hold the foam board in place while I taped the edges with aluminum tape. I put the vent cover back on while fishing the U clamp wires through the covers vent holes and then twist tied them on the outside of the vent cover. I tucked it in such that you can barely see it from the outside. If I ever need to, it can be undone quite easily for access to the frig back.
rickbecker is offline   Reply With Quote
Old 11-06-2024, 05:38 PM   #6
scottz
Site Team
 
scottz's Avatar
 
Join Date: Apr 2017
Location: Colorado Rockies
Posts: 2,059
M.O.C. #19755
Quote:
Originally Posted by rickbecker View Post
To not do so leaves your rig inside open to the out side and vulnerable to hot, cold and bugs!
How is your new set up any different than with the OEM refer?

I'm having trouble seeing the problem. In the last seven years (six with Norcold, one with JC unit) I have never had a problem with water or anything else (except a little dust) getting inside. However, my Montana has never been through a hurricane like the OP described.
scottz is offline   Reply With Quote
Old 11-06-2024, 05:57 PM   #7
rickbecker
Seasoned Camper
 
Join Date: Jun 2013
Location: Quincy
Posts: 79
M.O.C. #13543
The OEM Norcold was sealed around the front and had fiberglass insulation on the sides and top that would stop air flow and bugs. The JC unit install removes this fiber glass and has an air gap around the sides, top and bottom allowing air flow from inside RV for cooling. The cooling part of the refrig is in the sides and requires air flow but nothing like the Norcold with exposed fins at the back.
rickbecker is offline   Reply With Quote
Old 11-06-2024, 06:13 PM   #8
scottz
Site Team
 
scottz's Avatar
 
Join Date: Apr 2017
Location: Colorado Rockies
Posts: 2,059
M.O.C. #19755
Quote:
Originally Posted by rickbecker View Post
The OEM Norcold was sealed around the front and had fiberglass insulation on the sides and top that would stop air flow and bugs. The JC unit install removes this fiber glass and has an air gap around the sides, top and bottom allowing air flow from inside RV for cooling. The cooling part of the refrig is in the sides and requires air flow but nothing like the Norcold with exposed fins at the back.
We must have different units. I used the original Norcold cabinet and did not remove any insulation on the sides. My new cooling unit is entirely on the back, just like the Norcold cooling unit I removed; nothing on sides. My before/after installation is exactly the same except for a different cooling unit on the back (facing the outside vents).

The first photo shows the Norcold cooling unit, second shows the JC Refrigeration cooling unit, third photo is the final install looking through the lower vent; you can see insulation on the side. The fourth photo shows the cabinet before I put the refer back in place.

For this retrofit, JC Refrigeration recommends leaving the vents open; the JC unit also needs airflow.
Attached Thumbnails
Click image for larger version

Name:	4 Old Unit Exposed.jpg
Views:	12
Size:	207.7 KB
ID:	18536   Click image for larger version

Name:	7 New unit installed on cabinet.jpg
Views:	13
Size:	297.4 KB
ID:	18537   Click image for larger version

Name:	8 Installation Complete.jpg
Views:	13
Size:	247.2 KB
ID:	18538   Click image for larger version

Name:	9 Refer cabinet -2.jpg
Views:	21
Size:	231.0 KB
ID:	18540  
__________________
Scott & Alta
2017 Montana 3160RL Legacy
2022 F-450 Lariat Ultimate
scottz is offline   Reply With Quote
Old 11-07-2024, 10:29 AM   #9
rickbecker
Seasoned Camper
 
Join Date: Jun 2013
Location: Quincy
Posts: 79
M.O.C. #13543
You are absolutely right! My change was a full replacement of the Norcold with a Dutch Aire 2310 12 v. My apologies for not being clear or any confusion I caused.
rickbecker is offline   Reply With Quote
Old 11-07-2024, 11:09 AM   #10
Route66Rambler
Montana Fan
 
Route66Rambler's Avatar
 
Join Date: Feb 2019
Location: Oklahoma City
Posts: 184
M.O.C. #23433
We replaced the Dometic LP/electric fridge with a Norcold 12V compressor fridge. According the installation manual the fridge needs airflow from the bottom up the back out the top. In order for this to happen both of the original outside vents needed to be sealed. We used the old wood from the old fridge install to cover the inside of the vents then sealed with a couple coats of black paint to match the vents. Reinstalled the vent covers and ran a bead of silicone around the edges of the vent. No water has gotten yet. Also make sure the bottom of the fridge is open so that air can flow in and there is an air gap at the top. Otherwise it will over heat. Also you need make absolute sure the correct size of wiring is used or you will destroy the fridge.
__________________
Troy and Tracy Chaddon
2019 Montana High Country 330RL
2005 Ford F-350 "Bulletproofed"
Route66Rambler is offline   Reply With Quote
Old 11-07-2024, 12:03 PM   #11
432bartman
Montana Master
 
432bartman's Avatar
 
Join Date: May 2020
Location: UPLAND
Posts: 1,334
M.O.C. #26190
Just finished up swapping out my Norcold 2118, in our 2019 Montana 3560RL. I covered the upper and lower vents with 1/2" foam board and used waterproof Gorilla tape to seal it all up. To access the lower vent opening, I then cut 3 sides of the foam board as an access panel to gain access to the fridge plug. Once done, I just sealed those 3 cuts with more tape.
__________________
2019 Keystone Montana 3560RL, 2020 Chevy 2500 HD, Firestone airbags, Air Lift wireless compressor, Curt gooseneck, 20K Reese Goosebox, TST-507, USMC combat vet & retired LEO. Robert, Anika, Breanna, Dylan (daughter-in-law Stephanie). & our Great Pyrenees Layla
432bartman is offline   Reply With Quote
Old 11-07-2024, 02:21 PM   #12
scottz
Site Team
 
scottz's Avatar
 
Join Date: Apr 2017
Location: Colorado Rockies
Posts: 2,059
M.O.C. #19755
Quote:
Originally Posted by rickbecker View Post
You are absolutely right! My change was a full replacement of the Norcold with a Dutch Aire 2310 12 v. My apologies for not being clear or any confusion I caused.
No problem, my fault for the assumption.

Just to be clear for those that have retrofitted their existing Norcold 2118 with a JC Refrigeration compressor kit; they do not recommend covering the vents. This is page 41 of the installation manual.
__________________
Scott & Alta
2017 Montana 3160RL Legacy
2022 F-450 Lariat Ultimate
scottz is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 06:07 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.