2017 310 RE......Our range Exhaust is ducted to the inside,I would like to duct to the outside.Has anyone made this mod a DIY or had it done? There is cabinet space right above the micro so Iím guessing I could easily access the duct outside from here.Our micro is a High Pointe and not sure if I can change the venting.Any advice would be appreciated.
You would have to look at the microwave docs to see if it has a plate that can be shifted to vent out the back instead of the front. Or if you really want the vent, switch to a microwave than ca.
2012 F350 6.7 L dually, 2013 3800RE with 6 pt leveling, Sumitomo 17.5" load range h tires, Samsung 18 cu ft residential fridge, 8k Morryde I.S. with disc brakes. Full timing since 2012.
Am new to Montanna’s And my first quip is why didn’t they vent the hood to the outside! The expert went outside and said it is — all you need to do is open the two tiny side latches that keep it from flapping on the road, in storage and/or during high winds! Works great unlatched! Otherwise vents down onto the stove!
You should have a vent from the back of the convection oven/ microwave, it has tabs to keep it closed but some small stick on magnet tape works great. Just have to mess with until figure out how big to cut it.
This is one of the many little items that go un-noticed with the newer trailers ( especially the HC). They get your attention with all the tech bells and whistles, and the really important stuff is not there.
As long as there is not an aluminum stud where the vent would exit, it should be doable.
2018 Chevy 3500 LTZ Dually Diesel 4x4 CCLB
2011 Montana 3455 SA. 6 point level up. Disc brakes. Curt Q24 Hitch
Progressive EMS. Valterra tank valves. Sailun G637 tires. ARP fridge control. All led lighting. Mor Ryde IS