Adjusting/aligning 2.5x2.5 thru frame hydraulic Lippert slideouts

[daveinaz]

In case anyone else was a little confused about the proper order of adjusting their through the frame Lippert hydraulic slideout, I talked to Lippert and asked them if you should sync your slideout before you adjust it horizontally or vertically. They confirmed that you always adjust the synchronization first, then horizontally or vertically.

I thought this was the right sequence, but I called Lippert to confirm because in their tech sheet on adjusting slideouts, it shows how to synchronize them after the other adjustments.

In case you need it, the tech sheet is attached.

[1retired06]

What it does not tell you: before you do anything mark all adjusting bolts to capture your start point.

[daveinaz]

Originally Posted by 1retired06

What it does not tell you: before you do anything mark all adjusting bolts to capture your start point.

Good point! That'll give me something to use that silver sharpie on!