Screw stripped out in table stand

[mmgeol]

One of the screws stripped out in the table stand which is within the slide of my 2010 3150rl. I am leery about punching another hole in the base because of the slide. Does anyone have a good fix to secure the base?

Thanks.

[oldelmer1]

If you are talking a bout the 4 screws that hold the base to the floor, its no problem, s long as you use the same screws.

I have 1 that is stripped out too, but 3 is plenty to hold it in place.

We turned our table and put it into the corner, leave 2 chairs at home, gives up lots more room.

[Tom S.]

You could go up a size for the screw as long it's the same length. Or open the hole in the floor and put in a wall anchor (again the same length).

[DQDick]

Could also drop a piece of wooden match down in the hole and a drop of glue before putting the same screw back in.

[Emmel]

I took the screws out when we brought the Montana home from the dealer. Turned the table and did not put the screws back. The table has not moved and we traveled about 11k miles this last summer while touring the west.
Just another fix if interested.