We turned the table on our 2003 3295RK and never bothered screwing it back down. It stayed put. However, it was the trestle table so had support on both ends. On our 2007 3400RL, the table is the pedestal type with support only in the center. I'd screw this one back down if we turned it.
Bob & Lee, I don't think changing the lines would make any difference. I'm not an engineer, so I could be wrong about that. The slides move based on the least resistance method. You could temporarily change the order by closing all the valves except the one you want to move, then closing it and opening another, etc.
|