Byron - my living room ceiling cove lighting, when I tried to turn them on with the InCommand they started flickering for quite a while before they would finally turn on. Somewhere (this forum ??) someone said it is probably a bad relay on the InCommand circuit board in the basement. Suggestion was to buy new relays ($10-$12 on Amazon) or swap locations of the relays…which is what I did. The problem was solved immediately and works correctly today (2 yrs later). The pic below points to the control board and the black square relays. I think there is a diagram in the basement for which relays control what systems. Pull up on them to get them out. Swap 2 relays on the suspect circuit and see if it works.
__________________
MikenDebbie Aggie ‘77 in the sticks near Austin TX
2019 Chevy 3500 High Country DRW
2018 Montana 3921FB
Aussie Gus + Texas Heeler Jimmy
|