electrical issue

[bcrvman]

Originally Posted by iareapilot

We have 2022 3761FL. We used the electric fireplace and apparently when manufactured one of the hot lead screws wasn't tightened on the external 50 Amp plug. It welded to the cord. I replaced both the female and male plugs. Now all circuits work and all the breakers are working. However the fireplace outlet and the two outlets on either side are dead. I used a signal generator and can trace the wire from the dead outlet through the ceiling and to the area of the circuit breakers but the wire doesn't terminate at the breaker box it continues towards the refrigerator in the wall. I can get no signal at any of the wires entering the breaker box. It is as though there is an inline breaker but I find this unlikely that an inline breaker would be buried in the circuit. Would you have any ideas for me? Thanks, Steve

Do you have a 2nd fireplace? Only one can be on at a time, turn off the second and then you will be able to turn on the first.

[Mark7]

Originally Posted by BB_TX

Don’t know about the newer models, but a friend had a 2008 that had a toggle switch in the kitchen. One position he could use the microwave. Other position he could use the fireplace. But not both at the same time. My 2007 didn’t have a switch like that.

Did you check for anything like this? I have a 50 amp service and 2 A/C's and I have to choose between the microwave or the fireplace. The switch is a 3 way light switch and is right net to the microwave.