Keystone in-Command

[sdinsley]

No rear bumper, However you could have rack that acts as a bumper and storage area. There is a capacity of 300Lbs including the rack.

Here is a pic of the back of mine. No rack currently however I will be fabricating one from Aluminum soon.

[bowlesj]

Originally Posted by Dusters

Does anyone have a walk around to get the BCM to sync with the monitor on days it won't connect?

Back info: Power gen running (10.7 VDC min rqd), sync'd up to extend two of the electric slides, 15 minutes later no BCM sync. Powered down (computer reboot theory) several times and after another 20 minutes or so went to the manual switches on the board to close up the unit. The Red LED stayed on at the module, if I recall a blue LED should appear when sync'd.

This tends to happen about once a year and then just works after a little patience. The board was replaced last year while at the dealer for it's annual physical. I'm guessing for an industry post or recall.

Henry,

The only thing I could offer is the reset button in the center of the relay board. I have had one time in 2 years that I lost connectivity between the BCM and DC and wasn't able to reconnect with DC reboot. The reset button on the BCM worked perfectly in that condition. If you are seeing this about once per year the reset may be useful.

Now, on the hard wired connection between the 2, I'm jealous and will contact ASA to see what I can do to make that happen if possible. Always felt it should be a wired data connection for that part of the system.

John - 2016 3820FK

[Curtis]

Do not forget with the Legacy package you also get solid wood cabinets.

[WeBeFulltime]

Originally Posted by Jersey Devil

Does the legacy come with a rear bumper?
I thought I read someone said no with the rear cap.
If so not good if someone hits it in the rear even a light tap will probably be costly.

The Legacy package on the 3790/3791RD does not include a rear cap but does include a 2" receiver. If someone hits it in the rear the cost is their problem because they are at fault.

[Butch & Kathy]

My 3160RL legacy comes with a flimsy 1 1/4” hitch receiver on the rear. I wish I had your 2” hitch.

[scottz]

Originally Posted by Butchy

My 3160RL legacy comes with a flimsy 1 1/4” hitch receiver on the rear. I wish I had your 2” hitch.

Mine too. I've thought about putting a bicycle back there, but I don't think it would hold anything over 50Lb.

[DanandBrenda]

Mine came with the legacy package but have had several times that it had to reboot. Sometimes it takes a long time and several reboots to get it to work.

[WeBeFulltime]

Originally Posted by Curtis

Do not forget with the Legacy package you also get solid wood cabinets.

I would have to see cabinets from a Legacy and a Non-Legacy side by side to be convinced there is any difference in them. I checked the cabinets in our Non-Legacy 3791RD and can't find wrapped particle board anywhere. I can't say what kind of wood it is but it is solid wood.

[BRJ]

I tried to remove the password on my 2020 3120RL Legacy, but it seems impossible now. Perhaps new software. But after following the instructions here, it forces me to create a new password.