Hard wire camera

[h2ojocky]

I have installed a camera on the back of my 2955RL. I ran the wire above the plastic panels under the trailer. I am looking for assistance with getting the wire from propane compartment to the pinbox. What have you guys done? I tried fishing from front compartment but seem to hit foam or something.

[dieselguy]

I went from the belly into the front storage compartment by drilling a 1/2" hole in the lower rear wall. I then went up and across the roof of the front storage compartment to where the overhang is behind the pinbox. I carefully ran a fish tape along side the wires already coming from the Jbox behind the pin box. There is insulation and cross braces between the storage compartment and pinbox, so it is a bit tricky. I have my camera wire exiting the pinbox near the emergency breakaway cable.

[DarMar]

I loosened all the screws and removed many in the pin box area and ran the fish from the tank area toward the pin and after a few attempts at slightly different angles I found success.

[richfaa]

Sam as DarMar.

[h2ojocky]

Thanks for the help gentlemen. It looks like I was on the right track, I just need to fish a little more.