Wet bolt kit

[Ozz]

Doesn't look like $148.00 to me.

[Crossthread]

Ozz, Pre grease the zerts to make sure the holes are drilled correctly. Someone on the forum also mentioned that lightly tapering the grease exit ports helps while lubing the bushings. When I had a broken spring, and removed it, all the bushings were fractured (on all four springs).Bill

[Jolu]

Ozz when you get them on you will feel a $148 better.
Joe

[Exnavydiver]

Ozz, here is a link to my instruction post for the wet bolt install. As I said in that post, buy,borrow,steal,beg or find a 9/16 ream. once you have pressed the bushings into the spring ends run the ream through them to make sure you have the right of room for the bolt. There should be no resistance when installing them... Dave

[Ozz]

Thanks guys, will do. Appreciate the tips, it always helps when someone has been down that road. John Kohl called me with good info too.
Thanks again John.

[NCFischers]

I was going to tell you about the positioning of the grease holes but I'm sure John covered that already.