|
Hi I'm sorry I didn't get back on the forum.
I loosened the cables off and removed the pulleys.The screws are self tapping metal screws.
where each hole was I used a 3/4" hole saw and cut away the thin fibre board exposing the Aluminum.
I purchase a threaded rivet nut tool and kit. Drill the holes out to the correct insert size.
I used 1/4"x 3/4" nuts. The tool compresses the rivet tightly into the hole.
reinstalled pulleys and brackets and bolted up using 1/4" machine bolts.
Watch some u tube video's on how to set up and adjust slider cables.
|
Threaded Mode
