iN·Command is not registering the current temperature

[Vzfinancial@msn.com]

The hvac option on my iN·Command is not registering the current temperature in any of my zones, so the heat nor the a/c are activating!
Has anyone had such a problem, and what might be the issue??
(Sensors?)


Mod Update: Post moved to a new Thread as it was unrelated to the topic where it was.

[twindman]

The more I read about In Command the more I am glad I don't have it!! Seems a lot of problems and I don't see much advantage.

[LeftOverParts]

We had that happen once when our trailer was about 6 months old. Try power off (at the inCommand panel) to reset the system and then back on. This worked for us. Hasn't happened since.

In case that doesn't work for you. Here's a link to a keystone forum that talks to disconnecting power. See post 5 and 41.

https://www.keystoneforums.com/forum...t=45241&page=3

Would be great to know how you resolved it.

Good luck!

[Da40flyer]

Has happened to us a few times.

Solution each time was as @LeftOverParts indicated. Disconnect all power (including battery) to reset the system.

[M&M]

Most comments I read recommend a complete power cycle. The full power cycle would reset the gateways. Unless you know the fuses to pull for those devices cycling RV power is the route to go.

This is a link to resetting just the BCM.

https://www.in-command.net/wp-conten...and-ncsp35.pdf

Keeping my fingers crossed, but I have never had to do a power reset. Resetting BCM and display has cleared the few problems I’ve had.

[Vzfinancial@msn.com]

Thank you, that worked! Had to disconnect shore power and battery and then reconnect. It seemed to reset everything and worked. Thx much

[wed]

The 800 customer service for them is great reach out to them