Quote:
Originally Posted by Overlord
I got rid of my OEM landing gear, and installed Bulldog's BD500161 two motor set-up. Easy swap out.
The only thing that I haven't set up yet is being able to use the remote to operate the landing gear when I'm inside the truck when hooking up. I have a switch that disconnects their direct to battery connection through the Bulldog switches and circuit breakers, and need to add another switch to supply & cut off power from the remote control box so as not to back-feed current to each others circuit.
|
X2 on the Bulldog set. I ran new separate wiring and didn't attempt to hook up the remote. Mounted their switch panel on the front between the small front basement door and the edge near the propane tank door instead of the side and put a thermostat cover over it to keep direct water from hitting them.
They are an unbelievable improvement over the old single motor thing. I don't have to worry about slightly uneven sites either. Well worth it!