Washer/Dryer combo installed

[K&Gs3400RL]

Ran into one little snag but it's installed. When I picked the spot I wanted the ventI I drilled into an aluminum brace that ran horizontal with the floor, The top of it is right at 2ft. I put a bent coat hanger in it and turned it when I got to the 10 o'clock and the 2 o'clock position it quit turning. And when I poked it straight in I could hear it hit the outside wall of the beam. So I measured up another 2 1/2 inches and had no problems drilling. I did not want to go any higher than the bottom of the cabinet and was trying to keep it low for looks outside, Plus any higher and I would have had to run the vent in front of the cabinet which would have blocked most of it. And as you can see any lower and I would have been really close to the out side 110v outlet and not knowing where the wires are I did not want to chance going lower.

Ok so now everyone else who uses the Splendide WD2100XC? What are some tricks and tips For good results.


This is a duplicate post and has been locked. Please read and reply to the other posting
http://www.montanaowners.com/forums/...ad.php?t=51348

CRAFTt-Guy

[DQDick]

First and foremost read the manual. I didn't and the first load of whites I did I shrunk Joyce's socks to doll size. Also the fold the clothes and put them back in before drying actually is something you should do. I also purchased a couple of those little laundry balls from Walmart and I think that helps also.