Montana Door-side Decal

[Donjamin]

We own a 2016 3160 RL Legacy. The model decal beside our rig’s door is starting to fall apart. I am looking for a replacement decal. I have contacted Keystone customer service stating that I would like to purchase a replacement decal, but have yet to receive a response. Does anyone know of a source for these door decals?

Don

[BB_TX]

OK, that’s a new one. Have never seen anyone post that their model number decal had peeled. And have never seen any replacement decal web site offer replacement model number decals.

If no one can post a source, ask if anyone with the same model will take a good picture of theirs and send the picture to you. Take that picture to a decal or wrap shop and see if they can produce that for you.

[Donjamin]

Thanks Bill for your response. Yes, this is a new one. I searched on the forum and no one else has had this issue. I hope Keystone can help me out

Don

[Mikendebbie]

Donjamin - I made this pic from my decal then pasted your model number.
It is far from perfect...shadows and highlights mixed in the photo...even though I thought my pic would be straight-on - it is slightly skewed...but a decal print shop may be able to improve it for you.

[AZ Traveler]

Don,

Recommend you just remove the decal and not replace it.

[Donjamin]

Mike,

I made this pic from my decal then pasted your model number.
It is far from perfect...shadows and highlights mixed in the photo...even though I thought my pic would be straight-on - it is slightly skewed...but a decal print shop may be able to improve it for you.

Thank you! I’ll see if a local graphics shop can duplicate your picture of the decal.

Don

[Mikendebbie]

This image may be a smidge better to use than the first one...still far from perfect.

[Donjamin]

https://productiongraphicsland.blob....ixs9byjo5g.jpg

I didn’t hear back from Keystone, so I ordered a new model door label from makestickers.com. I was able to order an automotive bumper sticker label that measures 5” X 5”. This duplicates the previous model label we had that started to disintegrate on the rig. Order has shipped, so we’ll see what it turns out. Total cost was $11.32.

Don

[Donjamin]

We received our new/replacement side label today: