|
11-16-2020, 01:14 PM
|
#1
|
Established Member
Join Date: Jan 2020
Location: Lebanon
Posts: 16
M.O.C. #25640
|
Montana roof issues
I have a 2018 Montana 3811MS just noticed the caping in right side of roof about 30 ft is lifting the food material keystone is authorizing repair but in Ocala area an don’t know who would be the best place to take it ?
Looking for suggestions with in 50 miles or so that can repair/replace roof
|
|
|
11-17-2020, 06:53 AM
|
#2
|
Montana Fan
Join Date: Jul 2015
Location: Edgerton
Posts: 218
M.O.C. #17678
|
Huh? Caping? Food material? I think the autocorrect gremlins got you.
|
|
|
11-17-2020, 06:17 PM
|
#3
|
Montana Master
Join Date: Oct 2015
Location: westminster md
Posts: 2,318
M.O.C. #17894
|
I think he means the metal radius under the roofing along the edge is pushing the roofing up. That is common and no cause for concern unless staples are protruding through the roofing EPDM.
My advise is to leave well enough alone and keep an eye on it. The fix may well be worse that the problem.
__________________
2018 Chevy 3500 LTZ Dually Diesel 4x4 CCLB
2011 Montana 3455 SA. 6 point level up. Disc brakes. Curt Q24 Hitch. 5 step glow steps
Progressive EMS. Valterra tank valves. Sailun G637 tires. ARP fridge control. All led lighting. Mor Ryde IS
|
|
|
03-28-2021, 08:38 AM
|
#4
|
Established Member
Join Date: Mar 2021
Location: YAKIMA
Posts: 14
M.O.C. #28460
|
This has been an issue with Keystone for years and they seem to be unwilling to correct this. My unit is a 358RLT, 2013 and on my roof the stables are pushing up against the membrane. If you do not correct the problem the staples WILL make a hole in your roof and the aluminum shoulder edges WILL cut a hole in the membrane also.
Here is what I am doing. First of all I have a fully enclosed garage big enough to open my slides and still get around the trailer (38 ft). I understand most people don't have this advantage. So as for my fix-I have removed the drip rails along the side of the trailer and opened the front and back trim to release the membrane (mine is EPDM) carefully pull back the membrane up and back to expose the shoulder and staples. Most of the staples pull out when you do this. They do not hold into the wood. I removed all of the staples, located the roof joists, drilled a hole though the aluminum shoulder into the joists, squeezed gorilla glue between the shoulder and roof. Then screwed the shoulder down, stapled about every 2-3 inches with my staple gun. Over all the shoulder seams and along the line where shoulder overlaps the roof ran 3" EnternaBond tape. This will put a cushion between the screws and staples and the membrane. The factory used some thin black tape with a mesh that the staples pushed right through. Used roofing glue for the EDM and pulled it back down over shoulder. The drip rail screws hold the membrane so used same holes but did add butyl tape to back of rail-factory didn't. Resealed front and back.
I wanted to fix the issue BEFORE I had a leak in the roof and that would have been a VERY expense fix. If you want to see pictures of what I found after pulling back membrane just let me know.
|
|
|
03-28-2021, 09:27 AM
|
#5
|
Montana Master
Join Date: Jun 2017
Location: POINTBLANK
Posts: 1,888
M.O.C. #19944
|
Service Locations
Quote:
Originally Posted by Theo
I have a 2018 Montana 3811MS just noticed the caping in right side of roof about 30 ft is lifting the food material keystone is authorizing repair but in Ocala area an don’t know who would be the best place to take it ?
Looking for suggestions with in 50 miles or so that can repair/replace roof
|
Did you ask Keystone for Service Locations? When I had an issue, the gave me four. Pick a service/repair verses dealer if you have a choice - usually quicker service
__________________
RAM 22' DRW 3500 Crew LB 40 gal reserve tank / RETRAX Bed Cover / 2020 373RD HC / IS / MOPEKA Tank Monitor / Furrion Side&Rear Cameras
Slide Toppers / EMS-HW50C / Sailun 85's
3rd AC / Dometic 320
|
|
|
03-28-2021, 10:14 AM
|
#6
|
Established Member
Join Date: Mar 2021
Location: YAKIMA
Posts: 14
M.O.C. #28460
|
Keystone only gives you a one year warranty on the roof. Have seen many You Tube videos of people having this issue and some of the dealer "fixes" look terrible. Once the roof is torn or gets a puncher it will allow water to get into structure. Some say put a patch over it is good but if the area isn't squeaky clean the patch will leak. Depending on when you notice a hole and how long it has been there the damage could get quite costly. Not only entire roof replacement but structure too.
|
|
|
03-28-2021, 07:24 PM
|
#7
|
Established Member
Join Date: Jan 2020
Location: Lebanon
Posts: 16
M.O.C. #25640
|
Sad this is a on going issue all they have to do is use the right material
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Disclaimer:
This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.
All times are GMT -6. The time now is 03:34 PM.