|
08-02-2010, 10:16 AM
|
#1
|
Montana Master
Join Date: Aug 2008
Location: Shelburne
Posts: 688
M.O.C. #8693
|
Well, I dropped it, too...
I have no manufacturer to point my finger at, no friend gabbing at me, or vice versa. All my fault. I got on a spot, chocked the tires, yanked the hitch handle...then noticed that it might be a bit better a yard ahead. So, I took out the chocks, jumped in the cab, engaged the gear shift and gently pulled ahead...BANG! The universe cut me some slack, this time. The front of the Monty dropped five or six inches straight down onto the Bedlocker extruded rails, which are flat and two inches wide. The back of the hitch nudged up against the front of the tailgate. I stopped, calmed myself for a couple of minutes to prevent further stupidity, then chacked the tires, lowered the gear, lifted the Monty off the rails and inspected everything...everything works, the skin under the front of the Monty isn't even torn and the bedrails are just slightly deflected along their length, but still aligned well enough that the tonneau still operates just fine. I guess I was going so slow that the Monty was kinda "decanted" right onto the rails, which spread the load along the truck bed sides...
Don't try this at home, kids. Leave it to the self-professed professionals!
|
|
|
08-02-2010, 10:25 AM
|
#2
|
Montana Master
Join Date: May 2003
Location: New Bern
Posts: 4,294
M.O.C. #311
|
Dave,
I almost did that when I was preparing to install the bed saver. Glad there was only limited damage.
See ya at Goshen.
|
|
|
08-02-2010, 10:42 AM
|
#4
|
Montana Master
Join Date: Apr 2007
Location: South Shore
Posts: 6,009
M.O.C. #7110
|
It happens to the best of us!
Sorry to hear it happened and glad it wasn't any worse.
__________________
2011 GMC 4X4 dually CC, 6.6 Duramax with Allison Transmission. Formally 2001 Montana,2007 3400RL Montana, presently 2018 3401RS Alpine.
|
|
|
08-02-2010, 01:14 PM
|
#5
|
Montana Master
Join Date: Dec 2005
Location: Eugene
Posts: 1,062
M.O.C. #5091
|
Yup, been there, done that. Bought my bed saver right after that. Was changing a tire and rolled up on some blocks and pulled the pin, then decided I couldn't break the lug nuts loose, so pulled forward with the pin disengaged.....big noise, and I new what I did.
|
|
|
08-02-2010, 01:35 PM
|
#6
|
Montana Master
Join Date: Jun 2010
Location: Colorado Springs
Posts: 3,335
M.O.C. #10496
|
I hope this never happens to me. I'm checking out the bedsaver for my Superglide 16K now...
__________________
2010 3150RL
LevelUp, Dual 6 volt batteries, Progressive Industries EMS HW50C, Honda EU2000i Generator, Bridgestone Duravis R250 tires, Torklift Glowstep Revolution Stairs, LED Tail lights
2015 RAM 3500 Laramie SRW LB CC Cummins 6.7L Aisin Trans B&W RVK3600
|
|
|
08-02-2010, 04:32 PM
|
#7
|
Montana Fan
Join Date: Oct 2009
Location: Wilsons
Posts: 404
M.O.C. #9833
|
Glad you came out, for the most part it sounds like anyway, ok.
I'm a little paranoid about mashing the rails on my truck so I installed the
Blue Ox bedsaver. Well, Blue Ox put in on the hitch gratis (see earlier posts.)
Again, glad it worked out well.
Jerry
|
|
|
08-02-2010, 04:38 PM
|
#8
|
Montana Master
Join Date: Sep 2004
Location: sioux falls
Posts: 1,835
M.O.C. #2121
|
Ouch!
|
|
|
08-02-2010, 04:41 PM
|
#9
|
Montana Master
Join Date: Aug 2008
Location: New Bern
Posts: 4,387
M.O.C. #8728
|
It's cheap insurance!!
|
|
|
08-02-2010, 04:46 PM
|
#10
|
Montana Master
Join Date: Jan 2005
Location: North Ridgeville
Posts: 20,229
M.O.C. #2839
|
I figured early on that i would sooner or later drop the Montana although the last time i made a mistaaake was 1976 there fore I purchased a bedsaver.
|
|
|
08-02-2010, 05:00 PM
|
#11
|
Montana Master
Join Date: Oct 2007
Location: Land O Lakes
Posts: 2,752
M.O.C. #7753
|
Dave, quick run to the store and buy a lotto ticket. Maybe your luck will hold. Could have been much worse.. Like we used to say in the Navy: Plan the dive, Dive the plan...
|
|
|
08-02-2010, 06:10 PM
|
#12
|
Montana Master
Join Date: Sep 2006
Location: Casa Grande
Posts: 5,369
M.O.C. #6333
|
There's those that have and those that will!!! Glad yours didn't hurt that much, mine cost me a new tailgate. Those suckers are not cheap these days. Then had to have it painted, Whoa! I wish BlueOx made one for the Trailersaver hitch...
Drive Safe!!!!!
Phil
|
|
|
08-03-2010, 02:37 AM
|
#13
|
Montana Master
Join Date: Apr 2007
Location: Lakeside
Posts: 606
M.O.C. #7139
|
I hope you all have better luck with blue ox than I have. They sent one and doesn't even come close to fitting, when I called them they acted like they would help but just gave me a run around. good luck.
|
|
|
08-04-2010, 12:46 PM
|
#14
|
Montana Master
Join Date: Dec 2004
Location: Omaha
Posts: 2,084
M.O.C. #2780
|
ours didn't look like it would fit and then we realized that the hitch could be raised one notch and it worked perfect
__________________
Paul and Jan Kelpe
2014 Big Sky 3150RL
2015 GMC Denali, Duramax/Allison
|
|
|
08-04-2010, 03:57 PM
|
#15
|
Montana Master
Join Date: Aug 2008
Location: Shelburne
Posts: 688
M.O.C. #8693
|
I can't find a bedsaver for our 20.5K Pull-Rite on the Blue Ox website. Any ideas? Dave, you're right on about following the plan. But that $50M lotto prize is mine!
|
|
|
08-04-2010, 04:06 PM
|
#16
|
Montana Master
Join Date: Aug 2004
Location: Cedar Rapids
Posts: 4,876
M.O.C. #1944
|
Quote:
quote:Originally posted by exav8tr
There's those that have and those that will!!! Glad yours didn't hurt that much, mine cost me a new tailgate. Those suckers are not cheap these days. Then had to have it painted, Whoa! I wish BlueOx made one for the Trailersaver hitch...
Drive Safe!!!!!
Phil
|
Phil, I don't think you'll ever need one with the TrailerSaver hitch. It's the one hitch that I'm aware of that gives you a definite hook-up. I usually check the jaws to make sure they are closed after I lock the lever in it's travel position. I queried Hensley about a bedsaver and they assured me that there would be no need for one.
Orv
|
|
|
08-04-2010, 04:20 PM
|
#17
|
Montana Master
Join Date: Sep 2006
Location: Casa Grande
Posts: 5,369
M.O.C. #6333
|
Orv, I hate to say it but I have already done the dirty deed outside the Keystone Service Center while at Camp Keystone. Yep, it can be done. I didn't get it all the way in (I think I forgot to put it in the load position and it didn't catch), and forgot to check it and the DW got in to drive it to the dump site and KAAAABAAAMMMMM, down it went. Cost me a new tailgate. I agree, in a perfect world, on a perfect day, and you double check the jaws, it shouldn't have happened, BUT IT DID.....
|
|
|
08-04-2010, 07:10 PM
|
#18
|
Montana Master
Join Date: Oct 2007
Location: Hesperia
Posts: 1,321
M.O.C. #7787
|
Quote:
quote:Originally posted by ols1932
Quote:
quote:Originally posted by exav8tr
There's those that have and those that will!!! Glad yours didn't hurt that much, mine cost me a new tailgate. Those suckers are not cheap these days. Then had to have it painted, Whoa! I wish BlueOx made one for the Trailersaver hitch...
Drive Safe!!!!!
Phil
|
Phil, I don't think you'll ever need one with the TrailerSaver hitch. It's the one hitch that I'm aware of that gives you a definite hook-up. I usually check the jaws to make sure they are closed after I lock the lever in it's travel position. I queried Hensley about a bedsaver and they assured me that there would be no need for one.
Orv
|
There's aways a possibility for mistakes! No one perfect!
Jack
|
|
|
08-04-2010, 07:31 PM
|
#19
|
Site Team
Join Date: Aug 2007
Location: Omaha
Posts: 6,794
M.O.C. #7560
|
Dave-- Contact Blue OX and ask them directly if they make a bedsaver for your hitch! If not, they may ask you to send them your hitch and they MIGHT make one for you and it could be for FREE! They like to make bedsavers for people since then they can use it as a template and take it from there! Can't hurt to try! Let me know what they tell you. We had them at our Central PLains Rally and they MIGHT be at the Fall Rally IF they responded to my call to them to call Exnavydiver!! That could be a BIG IF , however! PM ma or email me your results. Dave MC have you heard anything on it yet?? Email me!
|
|
|
08-23-2010, 01:28 PM
|
#20
|
Montana Master
Join Date: Nov 2002
Location: Oceanside
Posts: 20,028
M.O.C. #20
|
Ohhhh, nooo, Dave! I live in fear of dropping mine on the bed.
What impresses me the most, though, is your willingness to own up to making the mistake. I think I'm king of mistakes, though.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|